Optimus AM/FM Stereo Cassette Owner's Manual page 10

12-2001.fm Page 10 Tuesday, July 13, 1999 10:47 AM
c. Adjust the nuts on the shafts
until the stereo's front panel
lines up properly with the
dashboard. If additional front
panel support is needed, you
can insert the supplied gas-
ket.
d. Place another
washer and nut on each shaft,
then tighten the nuts to secure
the stereo against the dash-
board.
5. Place the supplied trim plate and
one pair of the shaft-spacing
adapters over the shafts. Select
the pair of shaft-spacing adapt-
ers that fit over the shafts and
into the cutouts in the trim plate.
6. To further secure the stereo, use
the supplied hardware to attach
one end of the supplied metal
strap to the bolt on the back of
the stereo.
10
If necessary, bend the metal
strap to fit your vehicle's mount-
ing area. Then attach the other
end of the strap to a solid metal
part of the vehicle, using an
existing bolt or the supplied self-
tapping screw. This strap also
ensures that the stereo is prop-
supplied
erly grounded.
7. Place another supplied washer
and nut on each shaft, then
tighten the nuts to secure the
shaft-spacing adapters against
the stereo.
8. Place the supplied inner and
outer knobs on the shafts.
9. Reconnect the cable to the vehi-
cle battery's negative (
nal.
–
) termi-