Subscribing The Handset To A Dect System - NEC G955 Owner's Manual

DECT system configuration

Subscribing the handset to a DECT system

You must subscribe the handset to at least one DECT system before you
can use the handset to make a call. The handset can operate with a
maximum of four DECT systems, for which the handset stores the name
of the system in a subscription record. The subscribed name appears on
the handset display whenever the handset enters the range of the DECT
system.
If your supplier preinstalls the handset, you need not
Attention:
subscribe your handset to a system. When the handset is
not yet subscribed to a system, the message "Register"
appears on the display screen.
Use the PABX-PIN code to register the handset with a
DECT system.
Before you subscribe to a DECT system, obtain the following information
from your system administrator:
• PARK code: Use a PARK code system ID only if more than one
DECT system overlaps in your location.
• DECT system name: The name of the system to which you subscribe.
After you enter the system name, it appears on the idle display.
• Phone number: The local phone number assigned to your DECT
handset.
As soon as you have obtained information about your PIN
Attention:
code, you have only 15 minutes to subscribe the handset
set. In 15 minutes the PIN code is deactivated and it is
necessary to activate a new one.
To subscribe your handset to a DECT system, perform the following
steps:
1. Open the
40
Connectivity
"Accessing the Connectivity menu" (page
menu as shown in
39).