Installation - Ringdale Ethernet-Token Ring User Manual

Installation

Connecting the Router to the Ethernet Network
Insert the RJ-45 10baseT cable from the Ethernet network into the
RJ-45 port marked Ethernet Network 1.
The Green RX LED will blink when the router receives data from
the Ethernet network.
The Red TX LED will blink when the router transmits data to the
Ethernet network.
The Yellow Link LED indicates that the Ethernet network
connection is functioning.
Connecting the Router to the Token Ring Network
Insert either a Type 3 cable with an RJ-45 connector or a Type 1
cable with a 9 way DB connector from the Token Ring network into
the RJ-45 or DB 9 port respectively marked Token Ring Network
2. The router will auto-sense which Token Ring connector is being
used.
RD2004112901 | Eth_Tring_Rout_Man.doc
Front Panel Connections and LEDs
- 5 -