Harman Kardon AVR 510 Owner's Manual page 34

Advanced Features
the AVR 510 is turned off. Once the unit is
turned off, the semi-OSD displays will remain
activated, even if they were switched off for the
previous listening session.
To change the length of time that the semi-OSD
displays remain on the screen, go to the
ADVANCED SELECT menu as outlined
buttons n as
earlier, and press the
/
⁄ ¤
needed, until the on-screen › cursor is next to
the SEMI OSD TIME OUT line. Next,
buttons o
‹ ›
press the 31 until the
/
desired time in seconds is displayed. Note that
unlike most of the other options in this menu,
this is a permanent setting change, and the
time-out entry will remain in effect until it is
changed, even when the unit is turned off.
If you wish to make other adjustments, press
buttons n until the on-screen
the
/
⁄ ¤
cursor is next to the desired setting or the
RETURN TO MENU line and press the Set
button p. If you have no other adjustments
to make, press the OSD button v to exit the
menu system.
Full-OSD Time-Out Adjustment
The FULL OSD menu system is used to sim-
plify the setup and adjustment of the AVR 510,
using a series of on-screen menus. The factory
default setting for these menus leaves them on
the screen for 20 seconds after a period of
inactivity before they disappear from the screen
(Time-Out). Time-Out is a safety measure to
prevent image retention of the menu text in
your monitor or projector, which might happen
if it were left on indefinitely. However, some
viewers may prefer a slightly longer or shorter
period before the Time Out display.
To change the Full-OSD Time-Out, you will need
to make an adjustment in the ADVANCED
SELECT menu (Figure 9). To start the
adjustment, press the OSD button v to bring
the MASTER MENU to the screen. Press
button n six times, until the on-screen
the
¤
cursor is next to the ADVANCED line.
¤
Press the Set button p to enter the
ADVANCED SELECT Menu (Figure 9).
At the ADVANCED SELECT menu
(Figure 9) make certain that the on-screen
cursor is next to the FULL OSD TIME
buttons n as
OUT line by pressing the
/
⁄ ¤
buttons o/
needed. Next, press the ‹ ›
/
until the desired time is displayed in seconds.
Note that unlike most of the other options in
34 ADVANCED FEATURES
this menu, this is a permanent setting change,
and the Time-Out entry will remain in effect
until it is changed, even if the unit is turned off.
If you wish to make other adjustments, press
buttons n until the on-screen
the
/
⁄ ¤
cursor is next to the desired setting or the
RETURN TO MENU line and press the Set
button p. If you have no other adjustments
to make, press the OSD button v to exit the
menu system.
›
›
31
›