Features - Lightwave MX 8x8 DVI Pro User Manual

Features

50 meter input cable compensation – Using 24AWG high quality DVI cable, the
EDID routing – Advanced EDID management with EDID emulation. The user can
8 Inputs, 8 Outputs non-blocking cross point matrix architecture – The router
Single link, max 1.65 Gb/s DVI-D transmission (1920x1200 or 2048x1080) –
Supports all HDTV resolutions – 720p, 1080i and 1080p etc. without HDCP
Signal Detect LED-s at each input connector – Active DVI signals are detected:
Output PLL reclocking – (removes jitter caused by long cables ) each output has
Front panel buttons control – 8 source select, 8 destination select, Take, Load
Relegendable buttons – Each button has an easy removable flat cap and a
RS 232 or RS422 control – Simple ASCII based RS232 protocol is used for
Ethernet control – TCP/IP Ethernet 10Base-T or 100Base TX (Auto-Sensing)
Fiber cable support – Self powered DVI fiber cables using +5V from DVI sources
Universal power supply – MX 8x8 DVI Pro accepts AC voltages from 100 to 240
Power failure memory – In case of power failure the unit stores its latest
MX 8x8 DVI Pro automatically compensates up to 50 meter
cable length, which extends installation possibilities even on
highest HDTV or computer resolutions. In case of lower pixel
resolutions, this length can be even higher.
emulate any EDID on the switcher's inputs independently, read out
and store any attached monitor's EDID in 100 internal memory
locations, upload and download EDID files using Remote Control
Software.
allows any input to be switched to any output or more outputs
simultaneously.
The MX 8x8 DVI Pro routes any DVI single link signal between
25 and 165 MHz pixel clock frequency conforming to DVI 1.0
standard.
encoding - Unencrypted HDTV signals up to 165 MHz pixel
clock frequency regardless of resolution are passed through MX
8x8 DVI Pro
clock channel activity is green indicated, when signal is applied
to the input.
a clean, jitter free signal, eliminating signal instability and
distortion caused by long cables or connector reflections.
preset, Save preset, Panel Lock, Output Lock
translucent label which can be inserted under it to identify
sources and destinations.
switching, preset calling, status request, etc.
( VGA cards, etc.) usually are consuming more than 50 mA,
which load is maximum allowed by DVI 1.0 standard. MX 8x8
DVI Pro supports +5V 500 mA constant current output on each
DVI output to power long distance fiber optical cables.
Volts with 50 or 60 Hz line frequency on standard IEC
connector.
configuration, and after next power up it loads automatically.
MX 8x8 DVI Pro
User's Manual
Page 7 / 53