Installing Your Wine & Beverage Center; Unpacking Your Wine & Beverage Center; Leveling Your Wine & Beverage Center; Proper Air Circulation - Haier HVZ040ABH5SBJ User Manual

English
installing your wine & beverage center
Unpacking Your Wine & Beverage Center
1. Remove all packaging material. This includes the foam base and all
adhesive tape holding the wine & beverage center accessories inside
and outside.
2. Inspect and remove any remains of packing, tape or printed
materials before powering on the wine & beverage center
Leveling Your Wine & Beverage Center
• Your wine & beverage center has four leveling legs which are located
in the front and rear corners of your wine & beverage center. After
properly placing your wine & beverage center in its final position, you
can level your wine & beverage center.
• Leveling legs can be adjusted by turning them clockwise to raise your
wine & beverage center or by turning them counterclockwise to lower
your wine & beverage center. The wine & beverage center door will
close easier when the leveling legs are extended.

Proper Air Circulation

• To assure your wine & beverage center works at the maximum
efficiency it was designed for, you should install it in a location where
there is proper air circulation, plumbing and electrical connections.
• The following are recommended clearances around the wine &
beverage center:
Sides...............2" (50mm)
Top....................2" (50mm)
Back..................2" (50mm)
• Do not overfill your wine & beverage center for optimal wine &
beverage cooling.
Note: If your wine & beverage center has been tilted for any reason,
5
wait 24 hours before plugging it in.