Connecting To The Lan Line; Network Configuration - Sanyo PLC-WXL46 Network Manual

Chapter 2 Setup Procedures
Setting procedures and contents differ depending on the LAN installation location.
When installing, consult your system administrator to set up the LAN appropriately.

Connecting to the LAN line

Connect the LAN cable to the LAN connection terminal of the projector.
LAN Connection
Terminal
LAN Cable

Network configuration

Set the Wired LAN network through the projector menu. Detailed network settings will be
made with browser. Refer to "3. Basic setting and operation" (p.17-30). First, complete the
settings described in this chapter before performing steps in "3. Basic setting and opera-
tion."
Setting Procedure
1. Turn on the projector and select "Wired" from the menu bar of the projector.
The projector's LINK/ACT Lamp will be on or blink. If the "Wired setting" is "Off", it will not
be on. Follow step 2 and 3 to blink the lamp.
2. Select "Wired Setting" in the projector menu, and press SELECT button.
Select similar LAN environment among LAN1, 2 and 3 with the Point 7 8 buttons.
(LAN1, 2, and 3 are the factory default setting environments. You can select three dif-
ferent environment among setting LAN1–3. For each setting, refer to the chart on page
13.)
When selecting "Off" in the "Wired setting", the LAN connection will be cut off. Use the
function when disconnecting the projector from the network.
3. Press the Point 7 8 buttons then the "Please wait..." message will appear and switching
operation will start. Switching will take a while and after completing the operation, the
message will disappear. During the switching period, the projector cannot be operated.
1
ACT Lamp (Orange)
Blink orange when the
projector is sending or
receiving the data.
COMPUTER IN 2 /
MONITOR OUT
LINK Lamp (Green)
Light green when the
projector is connected to
the network correctly.
VIDEO IN
(M
S-VIDEO IN