Frigidaire GLHS38EGW6 Owner's Care & Use Manual

TO BE REMOVED BY THE CUSTOMER AFTER iNSTALLATiON iS COMPLETE.
f
[] iNSTALLATiON CHECKOFF LiST
Doors
[] Handbs are secure and tight
[] Door scab compbteUy to cabinet on aH sides
[] Doors are bveU across the top
Leveling
[] Refrigerator is bveL side to side and tilted 1/4" (6mm) front to back
[] Toe grHb is properUy attached to refrigerator
[] Cabinet is setting solid on aHcorners
[]
[]
Electrical Power
House power turned on
ice Maker
[] House water suppUy connected to refrigerator
[] Water & power couplings connected at door
[] No water leaks present at all connections - recheck in 24 hours
[] Ice Maker is turned ON,
[] Ice & Water Dispenser operates correctly
[] Front filter must be flush with filter housing (some models)
Final Checks
[] Shipping material removed
[] Fresh Food and Freezer controls set
[] Crisper Humidity controls set
[] Registration Card sent in
SHiPPiNG MATERIAL
HAND TRUCKING
* Load refrigerator from side of cabinet
only,
Do not run retaining straps over
handles,
Do not over4ighten retaining straps,
o Never use refrigerator handles to
move the refrigerator,
Remove tape from doors only after
unit is in place,
iNSTALLATiON CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation, and plumbing and electrical
connections:
Sides & Top.......... 3/8"
Back ....................... 1"
NOTE: if you are installing your refrigerator beside a wall,
leave 1/2" minimum between hinges and wail to allow for
the door to swing open,
Ensure icemaker is turned ON. To gain access to the ice maker,
slide the ice cream tray out. Check to see that the ice & Water
Dispenser is operating correctly. (See Automatic ice & Water
, Dispenser Features in LLse& Care Manual.) 1
I PIECE OF FOAM-
OR CARDBOARD
2 WIRE TIES
(Am[wire baske
will have 2 wir_
ties)
= _®=Vq _ I PIECE OF TAPE
_ 3[ PIECE OF TAPE OR
¢ _ _ 2 BLUE SHmPPING CLIPS
1 PIECE OF TAPE
_ _ -- SHELF SPACER WITH TOE GRILLE
i PIECE OF TAPE
' ...... Z PIECE OF TAPE
.. Remove Shipping material, iFeatures may vary per mode[.) ._
f
LEVEUNG AND ADJUSTING
All four corners of refrigerator must rest firmly on a solid --_--
floor, Your refrigerator has adjustable rollers to help level it
and to adjust the doors, J'/+ "_"
To [eve[ cabinet or change door height:
1, Remove toe grille,
2, Use a screwdriver, 3/8" wrench, or nutdriver to adjust the
rollers,To raise cabinet or door, turn screw clockwise, To
lower cabinet or door, turn screw counterclockwise,
Tools You Will Need:
Tu @ ;
..... ;;co
NiZ ;::
WATER SUPPLY
Connect water supply =check for water leaks, Turn [cemaker OFF
if water supply is not connected immediateJy. Connecting to a
reverse osmosis system is not recommended.
J
f CONTROLS
J
if you need to remove the doors to get your refrigerator in the house, please See
Door Rerrlova/Instructions in your Use & Care Manual,
v' See"Norma[ Operating Sights & Sounds" in the Use & Care
Manual so you understand the sounds you may hear once
your refrigerator is running,
_ PIease read entire Use & Care Manuatto become aware of
important safety instructions and to become familiar with your
new refrigerator,
x_ Send in Registration card to register your refrigerator,
x_ Congratulations! You are ready to enjoy your new refrigerator,
_F YOU ARE D_SSAT_SRED W_TH THE _NSTALLAT_ON OF YOUR REFRIGERATOR, PLEASE CALL THE STORE YOU PURCHASED _T FROM. P/N: 2 41582501