Advertisement
Quick Links
Download this manual
See also:
Use and Care Manual
installation
instructions
Ful! Size Tumble
Action
Washers
Before
beginning
installation,
carefully
read
these
instructions.
This will
simpfify
the
installation
and ensure the washer
is installed
correctly
and safely. Leave these instructions
near the washer
after installation
for future
reference.
NOTE:
The electrical
service
to the
washer
must
conform
with
local
codes
and
ordinances
and
the latest
edition
of the National
Electrical
Code,
ANS!/NFPA
70.
For your safety the information
in
this manual must be followed to minimize the risk
of fire or explosion or to prevent property damage,
personal injury or loss of life.
- Do not store or use gasoline or other flammable
vapors and liquid in the vicinity of this or any
other appliance.
- WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not
use any phone in your building.
• Clear the room, building or area of all
occupants.
• Immediately
call your gas supplier from a
neighbor's phone. Follow the gas suppliers
instructions.
• If you cannot reach your gas supplier, call
the fire department.
Installation
and service must be performed
by a
qualified
installer,
service agency
or the gas
supplier.
Printed in U.S.A.
Contents
SUBJECT
PAGE
Pre-lnstallation Requirements
2
Electrical Requirements
2
Grounding Requirements
2
Water Supply Requirements
2
Drain Requirements
2
Rough-In Dimensions
3
Location Of Your Washer
4
Unpacking
4
Installation
5-6
Replacement Parts
6
P/N 134849700 (0701)
Advertisement
Related Manuals for Frigidaire ATF8000FE0
Summary of Contents for Frigidaire ATF8000FE0
- Page 1 installation instructions Ful! Size Tumble Action Washers Before beginning installation, carefully read these instructions. This will simpfify installation and ensure the washer is installed correctly and safely. Leave these instructions near the washer after installation for future reference. NOTE: The electrical service to the washer...
-
Page 2: Drain Requirements
absence of local codes, with the National PRE-INSTALLATION REQUIREMENTS Electrical Codes, ANSI/NFPA 70 (latest edition). If in doubt, call a licensed electrician. DO NOT Tools Required for Installation: cut off or alter the grounding prong on the power Phillips screwdriver supply cord. -
Page 3: Rough-In Dimensions
ROUGH=IN DIMENSIONS 23¾" 24" (60.33) (60.96) - SLOE- 22" 25/8" (55.88) 35/8" (6.67) (9.21) 255/8" (65.09) 281/4" inches(cm) (71.76) NOTE: For pedestal installations, see additional installation instructions included with the pedestal. For stacking installations, see additional installtion instructions included with the stacking kit. -
Page 4: Unpacking
LOCATION OF YOUR WASHER DO NOTINSTALL YOUR WASHER: In an area exposed to dripping water or outside weather Carefully return the washer to an upright position. conditions. The ambient temperature should never be below 60 ° F (15.6 ° C) for proper washer (detergent breakdown) Carefully move the washer to within 4 feet (122cm) of the operation. -
Page 5: Installation
INSTALLATION STOP RIB- HOSE TABS L eve/ing the Washer Excessive noise and vibration can be prevented by properly leveling the washer. SPRING CLAMP For free standina installation and with the washer in it's final PROVIDED position, place a level on top of the washer. Adjust the HOSE leveling legs so the washer is level front-to-rear and side-to-... -
Page 6: Replacement Parts
PARTS If replacements parts are needed for your washer, contact the source where you purchased your washer, call 1-800-944-9044, or visit our website, www.frigidaire.com, for the Frigidaire Company Authorized Parts Distributor nearest you. Destroy the carton and plastic bags after the Cable washer is unpacked.