Frigidaire GLTF2070DS0 Installation Instructions
Full size tumble action washers
Hide thumbs
Also See for GLTF2070DS0:
- User manual (12 pages) ,
- Installation instructions (5 pages) ,
- Operating instructions (4 pages)
Advertisement
i
(
(
Installation
Instructions
Full Size Tumble Action Washers
Before beginning
installation,
carefully
read these instructions•
This will simplify the
installation and ensure the washer is installed correctly and safely. Leave these instructions
near the washer after installation for future reference.
NOTE: The electrical service to the washer must conform with local codes and ordinances
and the latest edition of the National Electrical Code, ANSIINFPA 70 or in Canada, CSA
C22.1 Canadian Electrical Code Part 1.
Contents
For your safety the information in
this manual must be followed to minimize the
risk of fire or explosion or to prevent property
damage, personal injury or loss of life.
- Do not store
or use gasoline
or other
flammable vapors and liquid in the vicinity of
this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not
use any phone in your building.
• Clear the room, building or area of all
occupants.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas suppliers
instructions.
• If you cannot reach your gas supplier, call
the fire department.
Installation and service must be performed by
a qualified installer, service agency or the gas
supplier.
Printed in U.S.A.
SUBJECT
PAGE
2
2
2
2
2
3
4
4
5
5
PIN 131997600 (0010)
Advertisement
Related Manuals for Frigidaire GLTF2070DS0
Summary of Contents for Frigidaire GLTF2070DS0
-
Page 1: Table Of Contents
Installation Instructions Full Size Tumble Action Washers Before beginning installation, carefully read these instructions• This will simplify the installation and ensure the washer is installed correctly and safely. Leave these instructions near the washer after installation for future reference. NOTE: The electrical service to the washer must conform with local codes and ordinances and the latest edition of the National Electrical Code, ANSIINFPA 70 or in Canada, CSA C22.1 Canadian Electrical Code Part 1. -
Page 2: Pre-Lnstallation Requirements
PRE-INSTALLATION REQUIREMENTS in accordancewith all local codes and ordinances or inthe absence of local codes, withthe National Tools Required for Installation: Electrical Codes, ANSI/NFPA 70 (latest edition). 1/4 in. nut driver If in doubt, call a licensed electrician. DONOT 3/8 in. socket with ratchet. cut off or alter the groundingprong on the power 3, 3/8 in. -
Page 3: Rough-In Dimensions
ROUGH-IN DIMENSIONS (67.9) .< (43.2) (I 52.4)-- 24 3/4 (7.3) (2.54_ (5,1) _' -- (62.9) (91.5) ii__ (3.81) Water Under Counter Cord (80.3) Power 331,_ (65) (87.9) _______ ]nlete BACK SIDE RollerWheels inch(cm) AdjustableLegs UNDER COUNTER INSTALLATION If an under counter* installationis desired, the washer MUST have a top sheet kit installed, PIN 131445600. Kit is available from an authorized parts distributor. -
Page 4: Locationof Your Washer
LOCATION OF YOUR WASHER DO NOT INSTALL YOUR WASHER: In an area exposed to dripping water or outside Remove the styrofoam base. weather conditions. The ambient temperature Carefully return the washer to an upright position should never be below 60 degrees F (15.6 and remove the carton. -
Page 5: Installation
1-800-944-9044 for the Frigidaire Company the base of the washer and snug with a wrench. Authorized Parts Distributor nearest you.