Locationof Your Washer; Unpacking - Frigidaire GLTF2070DS0 Installation Instructions

LOCATION OF YOUR WASHER
DO NOT INSTALL YOUR WASHER:
1. In an area exposed to dripping water or outside
weather conditions. The ambient temperature
should never be below 60 degrees F (15.6
degrees C) for proper washer operation.
2. In an area where it will come in contact with
curtains or drapes.
3. In an area (garage or garage-type building)where
gasoline of other flammables are kept or stored
(includingautomobiles).
4. On carpet. Floor MUST be solidwith a maximum
slope of 1/2 in. per foot (1.27 cm per 30.5 cm). To
ensure vibration or movement does not occur,
reinforcement of the floor may be necessary.
MINIMUM INSTALLATION CLEARANCES
When installed in alcove or closet:
Sides, Rear = 0 in. (0 crn)
Top = 0 in. (0 cm) Front Console Model
Top = 15 in. (38.1 cm) Rear Console Model
When installed in closet: Front = 1 in. (2.54 cm)
Closet door ventilationrequired: 2 Iouvered openings
each 60 irf (387 cmZ),3 in. (7.6 cm) from top and bottom
of door.
3. Remove the styrofoam base.
4. Carefully return the washer to an upright position
and remove the carton.
5. Carefullymove the washer to within4 feet (122cm)
of the final location.
6. Remove the following from the back side of the
washer: 4 bolts,
4 yellow plastic spacers,
3 metal "P" clamps.
7. Remove the service panel from the front of the
washer.
8. Remove the 4 nutsand 6 large washers that attach
the 2 yellow shipping braces to the drum and the
base. Lift up on the drum and remove the braces
(a yellow ribbon surrounds the items to be
removed).These braces mustbe removedto allow
the power supply cord to be released from the
shippingring.
9. Remove the large styrofoam block located under
the drum. Lift up on the drum, tilt the base of the
foam block inwards toward the rear of the washer
until free, then pull it out.
10. Remove and discard the yellow ribbon and label
from the front of the washer.
UNPACKING
1. Cut the shippingcartonalong the dotted line along
the base of the unit.
2. While in the cartoncarefully lay the washer on its
back side.
(_ , BOLT
SPACER
(_ "P" CLAMP
11. From the rear of the washer, carefully pull out the
power supply cord through the hole in the
backsheet.
12. Replace the service panel and screws.
NOTE: Ifthe washer is to be transported at a later
date, the shippingsupporthardware must
be reinstalled to prevent shipping
damage. Retain the hardware in the
plastic bag provided.
4