Frigidaire FFEC3625LS1 Installation Instructions Manual page 6

3. Models:32" Coil Elements Cooktops
1.Place cooktopintocountertop opening andcenter
unitincutout.
2. Remove a llsurface unitsanddripbowls.
3. Unitclamp clown information. Once unitis installed in
counter o pening, y oumustclampunitdownas
showninfigure12.
4. Putbackallsurface unitsanddripbowls.
5. Makeelectrical connections asoutlinedin "Electrical
Connection" s ection.
Reach d ownthrough surface unitopenings a ndinstall
thefourholddownretainers withscrews a sshown. B e
certain cooking top isfirmlyretained t o counter t op.
Cooktop Nylon s pacer
Hold down retainer
Burner box
Figure12
Countertop
4. Prior t o tightening installation s crews, exert
downward pressure o n burner boxto assure f langes
on burner boxrestfirmlyon counter. T ighten all
screws evenly.
5. Unitclamp downinformation. Once unitis installed in
counter o pening, y oumustclampunitdownas
showninfigure14.
6. Makeelectrical connections asoutlinedin "Electrical
Connection" S ection.
Toclamp down,insert b racket withoffsetsideof
angleintoslotoneach sideof unit.The screw should
thenberunthrough bracket a ndagainst bottom of
counter. T ighten untildraws down.
C0untert0p
C ookto_
___ , ,_
Holddow n retainer_,Jm_i_ Screw
Burner box
Figure 14
4. Models: 30" and 36" (36" X 211/2") Coil Elements
Cooktops
- These cooktops are designed to fit various cutout sizes.
The minimum and maximum cutout openings are
shown in figure 1.
- If cooktop is to be used in new installation, use
minimum cutout dimensions in figure 1.
- Attach cooktop to cabinet using wood screws through
holes in vertical walls of burner box.
- If cooktop is to be installed as a replacement in
an existing countertop opening (not exceeding
maximum cutout dimensions as shown in figure
1), the following steps must be taken:
1. Insert 4 screws and installation spacers through holes
in vertical walls of burner box (see figure 13).
2. Place cooktop into countertop opening and center
unit in cutout.
3. Tighten each screw finger tight or until spacers are
snug against burner box walls.
Spacer
J
_p,_Burner box
Screw
Figure 13
Checking Operation
Refer to the Owner's Guide for operation.
Do not touch cooktop glass or elements.
They may be hot enough to burn.
Model and Serial Number Location
The serial plate is located under the cooktop or in the
burner box and can be seen by lifting up the main top
of unit.
When ordering parts for or making inquires about your
cooktop, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your cooktop.
Before You Call for Service
Read the Avoid Service Checklist and operating
instructions in your Owner's Guide. It may save you time
and expense. The list includes common occurrences that
are not the result of defective workmanship or materials
in this appliance.
Refer to the warranty in your Owner's Guide for our
service phone number and address. Please call or write if
you have inquiries about your product and/or need to
order parts.