Advertisement
Available languages
Available languages
2. Wall Outlet
Location
12" (30.5 cm)
14"" i_
8,, d
I
1(20.3 cm)l _1_
_/
10,, (254 c m)
,',
Recommende
120V grounded
outlet on '
i rear wall
22"
CL of unit
(55.9 cm)
NOTE: If an outlet
is not available,
have one installed
by a qualified
technician.
"CL of unit
Figure
6
3. Clamp
Down
Information
Once the cooktop is installed in the counter opening, you
must clamp the unit down as shown.
Countertop
Figure 7
To clamp down, insert the bracket with the offset side of
the angle into the slots on each side of the unit. The
thumb screw should then be run through the bracket, up
against the bottom of the counter.
Tighten until the unit
draws down.
4. Provide
an Adequate
Gas Supply
This cooktop is designed to operate on natural gas at 4"
(10.2 cm) of manifold pressure only.
A pressure regulator is connected in series with the
manifold on the cooktop and must remain in series with
the supply line.
For proper
operation,
the maximum
inlet pressure to
the regulator
must be no more than 14" (35.6 cm) of
water
column
(W.C.) pressure.
For checking the regulator, the inlet pressure must be at
least 1 " (2.5 cm) (or 2.5 kPa) greater than the regulator
manifold pressure setting. The regulator is set for 4"
(10.2 cm) of manifold pressure, the inlet pressure must
be at least 5" (12.7 cm).
The gas supply line to the cooktop should be Y2" (1.3
cm) or 3A" (7.9 cm) pipe.
5. LP/Propane
Gas Conversion
This appliance can be used with Natural gas or LP/
Propane gas. It is shipped from the factory for use with
natural gas.
If you wish to convert your cooktop for use with LP/
Propane gas, use the supplied fixed orifices in the
package containing the installation Instructions Manual,
in a bag marked "FOR LP/PROPANEGAS CONVERSION".
Follow the installation instructions packaged with the
orifices.
The conversion must be performed by a qualified service
technician in accordance with the manufacturer's
instructions and all local codes and requirements of the
authority having jurisdiction.
Failure to follow
instructions could result in serious injury or property
damage. The qualified agency performing this work
assumes responsibility for the conversion.
Failure to make the appropriate
conversion
can result in personal
injury and property
damage.
Important:
Remove all packing material and
literature from cooktop before connecting gas and
electrical supply to cooktop.
Advertisement
