Important Notes To The Installer; Important Note To The Consumer; Important Safety - Frigidaire GLEC36S9EBC Installation Instructions Manual

Important Notes to the Installer
1. Read a llinstructions contained i nthese installation
instructions before installing t hecooktop.
2. Remove a llpacking material before connecting the
electrical supply t othecooktop.
3. Observe allgoverning c odes a ndordinances.
4. Besure to leave t hese instructions withtheconsumer.
Important Note to the Consumer
Keep these instructions withyourUse andCare Guide for
future reference.
IMPORTANT SAFETY
INSTRL!
S
,, Be sure your cooktop is installed and grounded
properly by a qualified installer or service
technician,
• These cooktops must be e[ectricaHy grounded in
accordance with local codes or, in their absence,
with the Nationa[ Electrical Code ANSI/NFPA No.
70--Jatest edition in the United States, or with
CSA Standard C22.1, Canadian Electrical Code, Part
1, in Canada.
_The electrical power to the cooktop
must be shut off while line connections are being
made, Failure to do so could result [n serious injury
or death.
Provide Electrical Connection
Install the junction box under the cabinet and run !20/
240 or 120/208 Volt, AC wire from the main circuit
panel. DO NOT connect the wire to the circuit panel at
this time.
Electrical Requirements
Observe all governing codes and local ordinances,
1. A 3-wire or 4-wire single phase 120/240 or 120/208
Volt, 60 Hz AC only electrical supply is required on a
separate circuit fused on both sides of the line (time-
delay fuse or circuit breaker is recommended). DO
NOT fuse neutral. The fuse size must not exceed tile
circuit rating of the appliance specified on the
nameplate.
2. These units can consume up to g700W at 240 Vac, a
circuit breaker of 40 Amp with wire gauge #SAWG
shall be used.
NOTE: Wire sizes and connections must conform with
the fuse size and rating of the appliance in accordance
with the National Electrical Code ANSI/NFPA No. 70-
latest edition, and local codes and ordinances.
An extension cord must not be used
with this appliance, Such use may result in a fire,
e[ectrka[ shock, or other personal injury,
3. The appliance should be connected to the fused
disconnect (or circuit breaker) box through flexible
armored or nonmetallic sheathed cable. The flexible
armored cable extending from this appliance should
be connected directly to tile grounded junction box.
The junction box should be located as shown in
Figure 2 with as much slack as possible remaining in
the (:able between tile box and the appliance, so it
can be moved if servicing is ever necessary.
4. A suitable strain relief must be provided to attach
tile flexible armored cable to the junction box.
Unpacking Instructions
.
2.
Mode[ and Serial Plate
Figure 3 (Under Cooktop)
Leave corner supports on cooktop until completion
of Electrical Connection.
Be sure the bottle of cleaner conditioner packed in
the literature bag is left where the user can find it
easily. It is important that tile ceramic-glass
smoothtop be pretreated before use. See Cooktop
Cleaning and Maintenance section in the Use and
Care Guide.