Figure - Frigidaire FFEC3225LWA Installation Instructions Manual

Cooktop Installation
1. All Ceramk-Glass Cooktops
Visually inspect the cooktop for damage. Also make
sure all cooktop screws are tight (see Figure 8).
SCREWS
Figure 8
Set the cooktop into the countertop cutout,
NOTE: Do not use caulking compound; cooktop
should be removable for service when needed.
Do not remove the nylon spacers on
the edges of the cooktopo These spacers center the
cooktop in the space provided. The cooktop must
be centered to prevent excess heat buildup that
may resuJt in heat damage or fire (see Figure 9).
6 NYLON SPACERS
POSITION BRACKETS
/
ON UNIT CUTOUT .<--" _-_ B>_
CENTER LINE .<_ s:;>" ._ ......
2 RETAINER "_'_ .............
BRACKETS ........
Figure 9
The retainer brackets MUST be installed, to meet
local codes or, in their absence, with the National
EJectricaJ Code ANSJ/NFPA No. 70--latest edition,
or with CSA Standard C22.1, Canadian EJectricat
Code, Part 1 (see Figure 10).
NYLON
SPACER
COUNTERTOP
Retainer Brackets Must
fBe At Lest 1/16"
Installed
(016 crn) BELOW
Countertop
RETAINER
BRACKET
Figure 10
Models: 26" and 36" (36" X 18") Coil Elements
Cooktops
Set the cooktop into the countertop cutout. Lift tile
cooktop and fasten the ends of tile box to the counter
with wood screws (figure 11). Lower the cooktop.
Align tile knobs on the shafts and press down with
even pressure.
COOKTOP _. COUNTERTOP
J _'SCREW
BURNER BOX
Figure 11
Models: 32" Coil Elements Cooktops
1. Place cooktop into countertop opening and
center unit in cutout.
2. Remove all surface units and drip bowls.
3. Unit (:lamp down information. Once unit is
installed in counter opening, you must clamp unit
down as shown in figure 12.
4. Put back all surface units and drip bowls.
5. Make electrical connections as outlined in
"Electrical Connection" section.