Warning Label - GE DNCD450GG9WC Installation Instructions Manual

Installation Instructions
• Apply duct tape as shown on the joint between the dryer
internal duct and the elbow.
DUCT
,TAPE
CAUTION:
Internal duct joints must be
secured with tape, otherwise
theg mag separate and cause a
safetg hazard.
ADDING ELBOW FOR EXHAUST THROUGH
BOTTOM OF CABINET
• Insert the elbow through the rear opening and connect it
to the dryer internal duct.
• Apply duct tape on the joint between the dryer internal
duct and elbow, as shown above.
k
CAUTION:
Internal duct joints must be secured with tape,
otherwise they may separate and cause a
safety hazard.
ADDING COVER PLATE TO REAR OF
CABINET
"-.-.'-4 ,_a,'-"_
"'"_'" ";'9
÷ .÷
÷
PLATE
(KITWE1M454)
Connect standard metal elbows and ducts to complete
the exhaust system. Cover back opening with a plate (Kit
WEllV]454) available from your local service provider. Place
dryer in final location.
-_WARNING-NEVER
LEAVE THE
BACK OPENING WITHOUT THE PLATE
(KIT WEIM454).
I_ CHANGING DIRECTION OF DOOR
OPENING
REMOVE/4 HOLE P LUGS AND
REMOVE/4 PLACE THEM INTHE HOLES
HINGE SCREWS. ON THE OPPOSITE SIDE.
ROTATE DOOR 1 80 °
AND REINSTALL.
1_-51 SERVICING
-_WARN ING-LABEL
ALL WIRES
PRIOR TO DISCONNECTING WHEN
SERVICING CONTROLS. WIRING
ERRORS CAN CAUSE IMPROPER AND
DANGEROUS OPERATION AFTER
SERVICING/INSTALLATION.
REGISTER YOUR NEW APPLIANCE TO RECEIVE ANY
IMPORTANT PRODUCT NOTIFICATIONS.
Please go to www.GEAppliances.com or moil in
your product registration card.
For questions on installation, call: 800.626.2000 (US) or
800-561-3344 (Canada).