GE GTDX185ED2CC Installation Instructions Manual page 7

Installation instructions
. Apply duct tape as shown on the joint between the
dryer internal duct and the elbow.
DUCT
CAUTION:
Internal duct joints must be
secured with tape, otherwise
they may separate and cause
U a safety hazard.
ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
. Insert the elbow through the rear opening and connect
it to the dryer internal duct.
. Apply duct tape on the joint between the dryer internal
duct and elbow, as shown on page 6.
J
CAUTION:
Internal duct joints must be secured with tape,
otherwise they may separate and cause a
safety hazard.
ADDING COVER PLATE TO REAR
OF CABINET {SIDES AND BOTTOM
EXHAUST}
PLATE
(KffWE1M454)
Connect standard metal elbows and ducts to complete
the exhaust system. Cover back opening with a plate
(Kit WE1M454) available from your local service provider.
Place dryer in final location.
WARNING-NEVER
LEAVE THE BACK
OPENING WITHOUT THE PLATE. {Kit
WEIM454}
In]CHANGING DIRECTION OF DOOR
OPENING
1. Open the door and remove the filler plugs opposite the
hinges. With the door completely open, remove the
bottom screws from each hinge on the dryer face. Insert
these screws about half way into the TOPholes, for each
hinge on the opposite side (where you removed the filler
plugs). Apply firm pressure to get the screw started.
2. Loosen the top screws from each hinge on the dryer
face half way. With one hand holding the top of the
door and the other hand holding the bottom, remove
the door from the dryer by lifting it UP and OUT.
3. Rotate the door 1800. Insert the door on the opposite
side of the opening by moving the door IN and DOWN
until the top hinge and the bottom hinge are resting on
the top screws inserted in step 1.
4. Remove the remaining screws from the side of the
opening from which the door was removed. With these
screws secure each hinge at the bottom. Tighten the
two top screws on each hinge. Reinsert the plastic plugs
on the side from which the door was removed.
REMOVE THE
BOTTOM SCREW LOOSEN THE TOP SCREWS
FROM EACH HINGE FROM EACH HINGE ON
ON THE DRYER FACE THE DRYER FACE
HALF WAY
MOVE THE DOOR IN AND
DOWN UNTIL THE TOP HINGE SECURE EACH HINGE
AND THE BOTTOM HINGES ARE AT THE BOTTOM AND
RESTING ON THE TOP SREWS TIGHTEN THE TWO TOP
INSERTED IN STEP 1 SCREWS OF EACH HINGE
7
7