GE DLLSR33EF5WC Installation Instructions Manual

Installatio
Instructi
Electric
49
ryer
or Visit our Web site at: www.GEAppliances.com (US)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•IMPORTANT - Save these
instructions for local inspector's use,
•IMPORTANT - Observe all
governing codes and ordinances.
• Note to Installer - Be sure to leave these instructions with
the customer.
• Note to Customer - Keep these instructions with your Use
and Care Book for filture reference.
• Exhausting the dryer to the outdoors is strongly recom-
mended to prevent large amounts of moisture from being
blown into the room.
• Before the old dryer is removed from service or discarded,
remove the dryer door.
• Service information and the wiring diagram are located in
the control console.
• Do not allow children on or in the appliance. Close
supervision of children is necessary when the appliance is
used near children.
FORYOUR SAFETY:
WARNING
• Use only rigid metal or flexible metal 4-in. diameter
ducVwork for exhausting to the outdoors. Never
use plastic or other combustible, easy-to-puncture ductwork.
• This appliance must be properly grounded and installed
as described in these instructions.
• Do not install or store appliance in an area where it
will be exposed to water and/or weather
• Install the dryer where the temperature is above 50°F
for satisfactory operation of the dryer control system.
NOTE: InstaRation and service of this dryer
requires basic mechanical and electrical skills.
it is your responsibility to contact a qualified
installer to make the electrical connections.
TOOLS YOU
WiLL NEED
SLIP JOINT PLIERS
[_
FLAT B LADE SCREWDRIVER
PHILLIPS SCREWDRIVER
%
MATERIALS YOU WiLL NEED
4"DIA, METAL DUCT
4"
(RECOMMENDED) DUCT
CLAMPS (2)
OR
4"SPRING
CLAMPS (2)
4"DIA, F LEXIBLE METAL DUCT _
(IF NEEDED)
%
4"DIA, METAL
ELBOW
DUCT TAPE
EXHAUST HOOD SAFETY G LASSES
_ 3/4" STF_N RELIEF
GLOVES ULRECOGNIZED
DRYER POWER
CORD K IT
(NOT PROVIDED
WITH DRYER)
UL RATED 120/240V, 30A
WITH 3 OR 4PRONGS,
IDENTIFY THE PLUG T YPE
ASPER THE HOUSE
RECEPTACLE BEFORE
PURCHASING LINE CORD.
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Prepare the Area and Exhaust for Installation of
New Dryer (see section 1).
Check and Ensure the Existing External Exhaust is
Clean (see section 1) and Meets Attached Installation
Specifications (see section 3).
Remove the Foam Shipping Pads (see section 1).
Move the Dryer to the Desired Location.
Connect the Power Supply (see section 2).
Connect the External Exhaust (see section 4).
Level Your Dryer (see section 5).
Step 8
Step 9
Check tile Operation of the Power Supply
and Venting.
Place the Owners Manual and tile Installation
Instructions in a Location Where They Will Be
Noticed By the Owner.
For Alcove or Closet Installation, see section 6.
For Bathroom or Bedroom Installation, see section 7.
For Mobile or Manufactured Home see, section 8.
For side or bottom exhaust, see section 9.