GE GFDS355GL1MV Installation Instructions Manual page 8

Installation Instructions
ADDING ELBOW AND DUCT FOR
EXHAUST TO LEFT OR RIGHT SIDE OF
CABINET
• Preassemble 4" elbow with 4" duct. Wrap duct tape
around joint.
• Insert duct assembly, elbow first, through the side
opening and connect the elbow to the dryer internal duct.
CAUTION:
Be sure not to pull o r domage the
electrical wiresinside t hedryer when inserting theduct.
DUCT
z TAPE
•Apply duct tape as shown on the joint between the dryer
internal duct and the elbow.
CAUTION:
Use 4" rigid metal ducting only
inside the dryer. Internal duct
joints must be secured with
tape, otherwise they may sepa-
rate and cause a safety hazard.
ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
• Insert the elbow through the rear opening and connect it
to the dryer internal duct.
• Apply duct tape on the joint between the dryer internal
duct and elbow, as shown above.
CAUTION:
Internal ductjoints must be securedwith tape,
otherwise they may separate and cause a
safety hazard.
ADDING COVER PLATE TO REAR OF
CABINET
P_TELA X "" """
(KIT WE1M454)
Connect standard metal elbows and ducts to complete the
exhaust system. Cover back opening with a plate (Kit
WEIM454) available from your local service provider.
Place dryer in final location.
-/ILWARNING-NEVER
LEAVE THE
BACK OPENING WITHOUT THE PLATE.
TO REGISTER YOUR DRYER
CALL TOLL-FREE
1-888-269-1192
Prompt registration confirms your right to protection under
the terms of your warranty.
www.GEAppliances.com (US}
For Questions on Installation, Call: 1-800-GECARES(US)or
1-800-:361-3400 (Canada).