Mount The Oveu - GE JVM1600 Series Installation Instructions Manual

Installation Instructions
MOUNT THE OVEN
FOIl EASIER INSTAI,IATION AND PERSONAI,
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS OVFN.
IMPORTANT: Do not grip or use handle
during
installation.
NOTE: If vour cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting ot the cord.
NOTE: We reconm_end using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from over
tightening screws.
NOTE: When mounting
the oven, thread power
cord through hole in
bottom of top cabinet.
Kee I) it tight throughout
Steps 1-3. Do not pinch
cord or lift oven bv
pulling cord.
[]I,ifl oven, it
tilt
fin'ward and hook
slots at back bottom
edge onto two lower
tabs of mounting plate.
/
_ Rotate
front of o_,en tl I)
against cabinet bottom.
CabinetFront
CabinetBottomShelf
, _
FillerBlock
\'F! _-Aligning Screw
OvenTop
[]Attach the oven to the top cabinet by inserting
3 sell=aligning screws through outer top cabinet
holes. Turn two flfll turns on each screw. Be sure
to keep power cord tight. Be careful not to pinch
the cord, especially when momlthlg flush to
bottom of cabinet,
[] Tighten the three screws to the top of the oven
completely. (_._hile tightening screws, hold the
oxen in place against the wall and the top
cabinet.)
/¢
_ Install grease filters. See the Owner's Manual
packed with the oxen.
18