Table of Contents
Advertisement
3.6
Special remarks on searching for satellite
Special remarks on searching for satellite
1.
With a weak GPS signal, it might be possible that the GPS location cannot be determined
With a weak GPS signal, it might be possible that
the system can be used as normal. However, finding the satellite will take longer and the optimal positi
the system can be used as normal. However, finding the satellite will take longer and the optimal position
the system can be used as normal. However, finding the satellite will take longer and the optimal positi
of the LNB will not be provided.
of the LNB will not be provided.
2.
If you began searching for the satellite
gan searching for the satellite during the determination of the GPS location, then the system
could suddenly stop searching and show
suddenly stop searching and show the following message:
This indicates that the system has found the GPS location and that the position of the LNB has to be
This indicates that the system has found the GPS location and that the position of the LNB has to be
This indicates that the system has found the GPS location and that the position of the LNB has to be
adjusted as shown on the display. If you do not adjust the LNB position, the system may not receive a
adjusted as shown on the display. If you do not adjust the LNB position, the system may not
adjusted as shown on the display. If you do not adjust the LNB position, the system may not
satellite signal.
Turn the LNB to the correct positi
searching.
3.
When the system finds a satellite with the correct characteristics, the dish will stop rotating. But if the
When the system finds a satellite with the
system concludes it has not found the selected satellite
system concludes it has not found the selected satellite after the internal check, the following message
will be shown:
The system will automatically resume searching for the selected satellite.
The system will automatically resume searching for the selected satellite.
3.7
Removing the control module
the control module
A release pin is located on the bottom of the control module. Pr
Remark:
The control module is splash-proof so that you ca
that you remove the control module
the control module following each alignment of the system to prevent theft and possible
water damage.
OPTIMAL SIGNAL
LNB IN POSITION +3
correct position and press the Start button (1) and then the system will resume
ASTRA 1 19.2°
WRONG SATELLITE
the bottom of the control module. Press this release pin to remove
The control module is unlocked after the release pen is pressed.
The control module is unlocked after the release pen is pressed.
Carefully remove the control module by pulling it to the right. Do this
gently to ensure that the current alignment of the dish is not altered.
proof so that you can align the system when it is raining
the GPS location cannot be determined, in which case
determination of the GPS location, then the system
and then the system will resume
characteristics, the dish will stop rotating. But if the
ess this release pin to remove the control module.
the control module by pulling it to the right. Do this
ensure that the current alignment of the dish is not altered.
n align the system when it is raining. We recommend
, the following message
to prevent theft and possible
Page 12
Advertisement
Table of Contents
