Advertisement
Step 5 - Remove Front Control
Console
•
Consult Service Guide 31-9226
or Mini-manual
for console removal
process.
Remove
protective
tape from the
bottom of the
foam strip.
Step 6 - Remove Vent Conduit
•
Remove
the 2 - T15 Torx screws to remove the
vent conduit from the front console.
•
Vent conduit can now be removed.
Step 7 - Install new Ul Control
Board
Control
Details on main control access can be found in
either Service Guide 31-9226
or Mini-manual
Verify correct model personality
jumpers
are in
correct position,
keys/buttons
and LED's will
not function
until appropriate
personality
is
selected.
PERSONALITY
Install new UI and re-install assembly
into top
console.
Place the strip inside the
bottom of the vent area of
the console.
Step 9 - Re-assemble
Vent Conduit
Carefully
insert the vent conduit into the vent
area of the front control, using care not to
damage
the newly installed foam strip.
Reinstall
2 - T15 Trox screws
Step 10 - Re-assemble
Inner to
Outer Door Panels
Reverse the dis-assembly
procedure
in the
Service
Guide or mini-manual,
make sure all
tabs are aligned and appearance
of gaps is
correct.
Step 11 - Re-install Door
,
Reverse door removal
process to re-install the
door and connect the door wire harness.
Step 8 - Install Foam Strip
This strip eliminates
condensation
pooling in the
outer vent area and must be installed.
•
Make sure the vent area of the front control
console is clean and dry.
°
Remove
the protective
paper from the foam
strip.
•
Place the foam strip on the bottom of the vent
area of the console.
Step 12 -Install
new Vent Cover
•
Install the new vent cover on the inner door to
vent conduit. This new vent cover allows more
air flow.
Step 13 - Test Operation
•
Re-apply
power, verify control and dishwasher
operation.
Advertisement
