GE GDT530P DO Installation Instructions

GE Appliances
Installation Instructions
Dry Enhancement Kit
WD35X10396
February 2013
Dishwasher Dry Performance
Verify proper heater operation, check for error
codes in diagnostic error mode, including
thermistor and/or wash temperature error codes.
Enter service mode to test heater operation. Full
directions to enter diagnostic and service mode
can be found in service guide 31-9226 or the
dishwasher's mini-manual.
If none of the above issues apply, follow all steps
in these instructions.
Step I - Remove Power from the
Dishwasher
Step 2 - Remove Inner Door Vent
Cover
To remove inner door vent, use 2 pocket screw
drivers, turn counter clockwise (Consult
Service Guide 31-9226 or Mini-manual). Old
vent cover should be discarded.
Models:
GDT530P DO
GDT550H DO
Parts Included:
This kit includes all parts needed for the above
models.
• U I (User Interface) Board WD21X10535
° 2 Vent Covers
° Foam Strip (black in color)
° Door harness wire tie (may not be needed)
° Installation instructionsWD00X1023
Tools You Will Need:
• 1/4" nutdriver
• T15Torx screwdriver
• Hinge locking tool (see service guide 31-9226)
Step 3 - Remove complete Door
assembly and separate the Door
Consult Service Guide 31-9226 or Mini-manual
for door removal process. A new wire tie for the
door wire harness is included in the kit. Should
the original tie become damaged, it must be
replaced.
Step 4 - Remove Top Ul Control
Bottom Cover
Remove the UI control bottom cover assembly
from the top control console, consult Service
Guide 31-9226 or Mini-manual.
Remove 4 -- 1/4" hex head screws to drop the
bottom cover from the control console.
GE Appliances
General Electric Company
Louisville, KY 40225
WD00X1023