Download  Print this page

GE GDT530P DO Installation Instructions

Dishwasher dry enhancement kit
Hide thumbs
   

Advertisement

GE Appliances
Installation Instructions
Dry Enhancement
Kit
WD35X10396
February 2013
Dishwasher
Dry Performance
Verify proper heater operation,
check for error
codes in diagnostic
error mode, including
thermistor
and/or wash temperature
error codes.
Enter service mode to test heater operation.
Full
directions
to enter diagnostic
and service mode
can be found in service guide 31-9226
or the
dishwasher's
mini-manual.
If none of the above issues apply, follow all steps
in these instructions.
Step I - Remove Power from the
Dishwasher
Step 2 - Remove Inner Door Vent
Cover
To remove inner door vent, use 2 pocket screw
drivers, turn counter clockwise
(Consult
Service
Guide 31-9226
or Mini-manual).
Old
vent cover should be discarded.
Models:
GDT530P
DO
GDT550H
DO
Parts Included:
This kit includes all parts needed for the above
models.
U I (User Interface)
Board WD21X10535
°
2 Vent Covers
°
Foam Strip (black in color)
°
Door harness wire tie (may not be needed)
°
Installation
instructionsWD00X1023
Tools You Will Need:
1/4" nutdriver
T15Torx
screwdriver
Hinge locking tool (see service guide 31-9226)
Step 3 - Remove complete Door
assembly and separate the Door
Consult
Service Guide 31-9226
or Mini-manual
for door removal
process. A new wire tie for the
door wire harness is included
in the kit. Should
the original tie become damaged,
it must be
replaced.
Step 4 - Remove Top Ul Control
Bottom Cover
Remove the UI control bottom cover assembly
from the top control console,
consult Service
Guide 31-9226
or Mini-manual.
Remove 4 -- 1/4" hex head screws to drop the
bottom cover from the control console.
GE Appliances
General Electric Company
Louisville, KY 40225
WD00X1023

Advertisement

Table of Contents
loading

  Related Manuals for GE GDT530P DO

  Summary of Contents for GE GDT530P DO

  • Page 1 GE Appliances Installation Instructions Dry Enhancement WD35X10396 February 2013 Dishwasher Dry Performance Step I - Remove Power from the Dishwasher Verify proper heater operation, check for error codes in diagnostic error mode, including Step 2 - Remove Inner Door Vent...
  • Page 2 Step 5 - Install new UI Control Board Remove the protective paper from the foam Control strip. Place the foam strip on the bottom of the vent area of the handle bracket. The UI bottom cover and light pipe are snapped together, to remove use a small...

This manual is also suitable for:

Gdt550h doWd35x10396Gdt530p*d0Gdt550h*d0