Advertisement
Step 5 - Install new UI Control Board
Control
The UI bottom cover and light pipe are
snapped
together,
to remove use a small
screwdriver
on either end to start releasing
tabs. Once started the tabs will release by
working the light pipe back and forth to
separate the light pipe from the bottom cover.
Button
Light Pipe
Remove the protective
paper from the foam
strip.
Place the foam strip on the bottom of the vent
area of the handle bracket.
Remove
protective tape
from bottom of
foam strip,
place the strip
inside the
bottom of the
vent area of the
handle bracket,
with adhesive
down
Verify correct model personality
jumpers
are in
correct position,
keys/buttons
and LED's will
not function
until appropriate
personality
is
selected.
©
8
4
I
GDT550H
©
8
4
I
GDT530P
Install new UI and re-assemble
cover, light pipe
and top console assembly.
Step 6 - Remove Vent Conduit
,
Remove
the 2 - T15 Torx screws to remove the
vent conduit from the handle bracket on the
outer door panel.
,
Vent conduit can now be removed.
Step 7 -Install
Foam Strip
This strip eliminates
condensation
pooling in the
outer vent area and must be installed.
°
Make sure the vent area of the handle bracket
is clean and dry.
Step 8 - Re-assemble
Vent Conduit
Carefully
insert the vent conduit into the vent
area of the handle bracket on the outer door
panel, using care not to damage the newly
installed foam strip.
Reinstall
2 - T15 Trox screws
Step 9 - Re-assemble
Inner and
Outer Door Panels
Reverse the dis-assembly
procedure
in the
Service
Guide or mini-manual,
make sure all
tabs are aligned and appearance
of gaps is
correct.
Step 10 - Re-install Door
°
Reverse
door removal
process to re-install the
door and connect the door wire harness.
Step 11 -Install new Vent Cover
•
Install the new vent cover on the inner door to
vent conduit. This new vent cover allows more
air flow.
Step 12 - Test Operation
•
Re-apply
power, verify control and dishwasher
operation.
Advertisement
