Hardware Installation; Software Installation - Alfa Network AWAP602HW User Manual

1 Installation

1.1 Hardware Installation

Step 1: Place the Wireless LAN Broadband Router to the best optimum
transmission location. The best transmission location for your
WLAN Broadband Router is usually at the geographic center of
your wireless network, with line of sign to all of your mobile
stations.
Step 2: Connect the WLAN Broadband Router to your wired network.
Connect the Ethernet WAN interface of WLAN Broadband Router
by category 5 Ethernet cable to your switch/ hub/ xDSL modem or
cable modem. A straight-through Ethernet cable with appropriate
cable length is needed.
Step 3: Supply DC power to the WLAN Broadband Router. Use only the
AC/DC power adapter supplied with the WLAN Broadband Router;
it may occur damage by using a different type of power adapter.
The hardware installation finished.

1.2 Software Installation

There are no software drivers, patches or utilities installation needed,
but only the configuration setting. Please refer to chapter 3 for software
configuration.
Notice: It will take about 55 seconds to complete the boot up sequence
after powered on the WLAN Broadband Router; Power LED
will be active, and after that the WLAN Activity LED will be
flashing to show the WLAN interface is enabled and working
now.