Advertisement
- Before using the appliance for the first time, remove all the transportation
protection devices and retain for subsequent transportation of the
appliance.
- For any future transport, the transport braces must be refitted - this
prevents the machine from being damaged. -> page 6.
- Keep the bolt and sleeve screwed together.
... until they are freely movable in the sleeves.
Water supply hose:
Attention:
The water supply hose must not be kinked, bent or flattened in such a way as to
potentially diminish water flow, Also, do not cut or modify the hose.
Optimum water pressure should be between: 14.5 to 120 p.s.i. (1-10bar)
- When the faucet is turned on, the water flow is at least 2,2 U.S. gallons (8 liters) per minute.
- If the water pressure is higher, install a pressure reducing valve.
Connect water supply hose to the faucet.
Attention:
Plastic threads of water connections must
be hand-tightened
ONLY, Do not tighten with a
or:
wrench or pliers
Use a Y-connector to split a single cold
Turn on the faucet (faucets) fully,
water outlet in order to provide two water
Check for leaks at the connection points,
supply hose inlets,
A - c01dwater
B - hot water
(max. 60_C/140F)
---A
- The washing machine must only be operated with cold and hot (max. 140_F/ 60%) faucet
water. Do not connect the appliance to the mixer faucet of an unpressurized hot-water
boiler.
- To prevent water damage, the hot and cold water valves should be accessible when the
washing machine is in place and should always be turned off when the washing machine is
not in use.
- If installing the washing machine in a new building or a building in which the plumbing system
was recently installed or upgraded, flush the lines before installing the washing machine to
remove any sand, dirt or residue.
- The connection points are under full water pressure. Check seal with faucet fully open.
- To prevent leakage or water damage, follow the instructions in this chaPrLer!
- Use only new water supply hoses, do not re-use an old hose. Only use the inlet hose
sup_pliedor one which was purchased from an authorized dealer.
- If in doubt, have the appliance connected by a technician.
Water drainage hose:
Attention:
Do not kink or overextend the drain hose,
Height difference
between installation
area and outlet:
min. 23in. / 60cm - max. 39in. / 100cm
Drainage into a sink/bath tub:
Attention: Secure the drainage hose to prevent it from slipping out of the sink.
Attention:
The plug must not be in the plug hole. When the water is being
pumped out of the washing machine, check that the water drains away
quickly enough. Do not insert the end of the drainage hose into the
pumped off water! There is a Ksk that water will be drawn back into the
washing machine!
Drainage into a standpipe
or in wall installation:
Use the U-bracket. Attach the U-bracket to the end of the hose and insert
end of hose into standpipe or wall drain. Use a strap or cable tie connected
to U-bracket to hold hose in place.
Drainage into a siphon:
Attention:
Secure connection point with hose clip,
Q 0.94" / 24mm - 1.57" / 40mm
II
Advertisement
