Gigabyte 6VMM User Manual page 69

Onboard Serial Port 2
Auto BIOS will automatically setup the port 2 address (Default Value).
3F8/COM1 Enable onboard Serial port 2 and address is 3F8.
2F8/COM2 Enable onboard Serial port 2 and address is 2F8.
3E8/COM3 Enable onboard Serial port 2 and address is 3E8.
2E8/COM4 Enable onboard Serial port 2 and address is 2E8.
Disabled Disable onboard Serial port 2.
Serial Port 2 Mode
ASKIR Set onboard I/O chip Serial Port 2 to ASKIR Mode.
IrDA Set onboard I/O chip Serial Port 2 to IrDA Mode.
Normal Set onboard I/O chip Serial Port 2 to Normal Mode. (Default Value)
Duplex Mode
IR Function Duplex Half.
Half Duplex
Disabled this function. (Default Value)
N/A
IR Function Duplex Full.
Full Duplex
On Board Parallel port
378 Enable On Board LPT port and address is 378.
278 Enable On Board LPT port and address is 278.
3BC Enable On Board LPT port and address is 3BC.
Auto Set On Board LPT port is Auto. (Default Value).
Disabled Disable On Board LPT port.
Parallel Port Mode
EPP Using Parallel port as Enhanced Parallel Port.
ECP Using Parallel port as Extended Capabilities Port. (Default Value)
Normal Normal Operation.
Parallel Port DMA
Auto Set Auto to parallel port mode DMA Channel. (Default Value)
N/A Disabled this function.
3 Set Parallel Port DMA is 3.
1 Set Parallel Port DMA is 1.
0 Set Parallel Port DMA is 0.
Parallel Port IRQ
7 Set Parallel Port IRQ is 7.
Auto Set Auto to parallel Port IRQ DMA Channel. . (Default Value).
5 Set Parallel Port IRQ is 5.
68
BIOS Setup