Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for LightSpeed Technologies 800iX
Summary of Contents for LightSpeed Technologies 800iX
- Page 1 800iX LightSPEED Infrared Wireless Microphone System U s e r M a n u a l...
-
Page 2: Safety Instructions
This Light- 5. Water and Moisture— SPEED product should not be used near water. This LightSPEED product 6. Heat— should be situated away from heat sources such as radiators, etc. i | 800iX User Manual... -
Page 3: Daily Use Instructions
LightMic to into the charging Plug the ON/OFF switch on the side of cable to recharge at the end of the day. the LightMic and speak normally. LT-71 AUDIO OUTPUT DC POWER 16V/1A — CHARGE LEVE MIC L 2.06/2.54 800iX User Manual | ii... -
Page 4: Table Of Contents
8 0 0 i X U s e r M a n u a l TABLE OF CONTENTS 800iX CLASSROOM AMPLIFICATION SYSTEM Safety Instructions Daily Use Instructions 800iX Infrared Wireless Microphone System System Components System Installation Unpacking Your System Location of the Receiver... -
Page 5: 800Ix Infrared Wireless Microphone System
The 800iX is a two-channel receiver that allows the use of up to two additional microphones simultaneous- ly. A standard IR sensor can provide high quality reception in rooms up to 1600 square feet. -
Page 6: System Components
8 0 0 i X U s e r M a n u a l SYSTEM COMPONENTS 800iX Infrared Wireless Microphone Receiver Sensor Cable LT-71 SR-70F Infrared Sensor Power Supply LT-71 LightMic™ Transmitter Optional HM-70 Handheld Microphone Helpful Keep ALL packaging materials. If the system... -
Page 7: System Installation
ADJ. the cable from the 1/4” 2. Connect TV/VCR CD/DVD SPEAKER OUTPUTS DC POWER CHARGERS 800iX audio output jack on the 800iX to INPUT 24VDC PAGING INPUT the input jack on the 850iR, 800iX, 850iR Receiver/Amplifier or an existing amplifier. AUDIO INPUTS 250 400... -
Page 8: Ir Sensor Installation
3. Connect sensor cable to one of the sensor sensor cable into one of the sensor inputs on the back of the 800iX. inputs on the back of the 800iX. Sensor Placement in the Classroom Sensor location is very important for optimum perfor- mance of the 800iX Classroom Amplification System. -
Page 9: Front Panel Controls
1. POWER Switch/POWER Indicator: flash green when audio (voice) This switch is used to turn the from the microphone is detected. 800iX ON (switch up), or OFF (switch down). When the POWER Controls the 4. A VOLUME: switch is in the ON position, the volume level of the teacher POWER light will glow red. -
Page 10: Rear Panel Controls
This 1/4” unbalanced 3. AUDIO OUTPUT: Connect additional sensors to the audio output jack may be connected to 800iX to cover large or odd-shaped a “line in” jack on a mixer/amplifier. classrooms. This output is a mixed audio of channels A and B. -
Page 11: Lightmic Controls And Connections
This switch allows for selection Plug Charger Input (CHARGER): between Channel A or B. If you are the charging cable from the 800iX using a single microphone/transmit- into this jack for daily charging. ter for your system, we recommend The LED on the front will glow red using Channel A. -
Page 12: Initial Setup
1. Ensure all cables are appropriately routed out of walking paths and work areas to prevent safety hazards to individuals in the room. 2. The amplifier packing material should be kept for warranty shipping purposes. Dispose of remaining system-packing material in the appropriate refuse containers. Leave microphones charging so they are ready for use. Microphones will need to be charged on a daily basis. 8 | 800iX Users Manual... -
Page 13: System Operation
8 0 0 i X U s e r M a n u a l SYSTEM OPERATION TURNING THE SYSTEM ON 1. Turn the 800iX switch to the ON position. The red LED on the switch will glow. 2. Slip the LT-71 LightMic with lanyard around the neck and position the top of the microphone just below the collarbone. -
Page 14: Charging The Lightmic
2. Connect one end of the charging cable to the LightMic and the other end to one of the charger jacks on the back of the 800iX. The LED on the front of the LightMic will glow red while charging. -
Page 15: Operating The Optional Hm-70 Handheld Mic
OFF position 5. Slide the system. This is useful if you to turn off the HM-70. (Make sure the power indicator light is off.) wish to temporarily turn audio off during a private conversation. 800iX User Manual | 11... -
Page 16: Charging The
The 800iX can be left on, but must ing correctly. The light goes out be connected to AC power in order when fully charged. -
Page 17: Tips On Classroom Amplification
Repair by other than LightSPEED or its authorized service agencies will void this guarantee. Information on authorized service agencies is available from LightSPEED Technologies, Inc. Our Service Department is available M–F, 5 a.m. – 5 p.m. Pacific Time, to handle all your repair/replacement needs. 800iX User Manual | 13... -
Page 18: Troubleshooting Guide
WILL occur—adjust accordingly. If you review these instructions and still have questions, write down the serial number and model number of your system and call LightSPEED Technical Services at 800.732.8999, 5 a.m. – 5 p.m. Pacific Time. 14 | 800iX User Manual... -
Page 19: System Specifications
1.375” x .75” x 4.625” Weight 3.7 oz IR SENSOR SPECIFICATIONS Working Range Up to 1600 square feet per sensor Cable 50 ft., Plenum-rated Mounting Ceiling clip/Wall bracket Dimensions 4.25” (Diam.) x 2.0” (H) Weight 4.5 oz 800iX User Manual | 15... -
Page 20: Individual Components And Optional Accessories
Rechargeable AA battery (Nickel Metal Hydride) AC-TCC7 Charging cable for LT-71 and HM-70 microphones AC-LTCB Lavaliere cord for LT-71 PS-16V-1.0 Power supply/battery charger for 800iX Infrared sensor with cable and wall or ceiling mounting SR70F bracket Optional Accessories AC-71CC Cradle charger... -
Page 21: User Notes
USER NOTES Record your system serial numbers and purchase information. This is helpful when ordering additional components, accessories, and/or warranty service. Components Serial Number 800iX Microphones Sensors Speakers Purchase Information Your School/Organization District Purchase Date Invoice 800iX User Manual |17...
Need help?
Do you have a question about the 800iX and is the answer not in the manual?
Questions and answers