Jenn-Air MK2167 Installation Instructions Manual page 2

INSTALLATIONINSTRUCTIONS
t'O0_S 3_J
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
• Measuring tape • Drill
• Pencil • 7/64" drill bit
• Phillips screwdriver
Parts Supplied (not shown to scale
Rails (2)
Bottom duct Trim kit frame
t_
Short screws (14)
(11 + 3 extra)
Long wood screws (6 - painted)
(4 + 2 extra)
' _ _,_ Ii_ _ _ '_ _
Locust ( n @ @qu ®ments
The microwave oven may be installed over a built-in oven. If
installing over a built-in oven, make sure there is a minimum of 3"
(7.6 cm) between the top of the lower oven cutout and the
microwave oven cutout floor.
The microwave oven may also be installed in a cabinet by itself
(without a built-in oven below). For best usability, we recommend
a minimum distance of 36" (91.4 cm) from the floor to the cutout
floor.
Make sure the surrounding cabinetry has clearance to open and
close freely. Allow a clearance of at least 1%d' (4.0 cm) below the
cutout floor (3" [7.6 cm] for installation above a built-in oven), and
a clearance of at least 2" (5.1 cm) above the cutout opening.
2 II
(5.1cm)
1 9/16"
2 II
crn)
3 II
A. Upper cabinet D. Lower cabinets
B. Microwave oven cutout E. Floor
C. Lower oven cutout
, ,4
!
17" (43 2 cm) _
mln.
171/8 ,,
max.
3 II
_, 23 Vs" (58.7 cm)._--
(2.7 cm)
x
XA
1%6"
(2.7 cm)
liiii;i_;ii_;ii_;ii(t B
A. Trim kit frame overhang
B. Cutout for lower oven
NOTES:
Height dimension is critical: 17" (43.2 cm)minimum, 17V8"
(43.5 cm) maximum.
Width and depth measurements have _+1/16" (2 mm)
tolerance.
3" (7.6 cm) minimum dimension is from lower oven cutout
ceiling to microwave oven cutout floor.
Trim kit frame extends 1Vld' (2.7 cm) above and below the
cutout opening.
I 26 7/a" (68.2 cm)*
,1 29 3/4" (75.6 cm)**
T _ 22 3/4" (57.8 cm) --
3 7A6"
I
19 %" (8.7 cm)
(48.6 cm] 12 1/4"
(31 Jim)
__ 2 V_d' (5.2 cm)*
3 V_" (8.9 cm)**
1 3A6" (3.0 cm)
*27" (68.6 cm) trim kit
**30" (76.2 cm) trim kit
.I
2