Download Print this page

Jenn-Air JJW9330DDB Installation Instructions Manual page 8

27" (68.6 cm) and 30" (76.2 cm) electric single and double built-in oven
Hide thumbs Also See for JJW9330DDB:

Advertisement

Available languages

Available languages

4.
On some models, the bottom oven trim is taped to the top of
the oven chassis enclosure. See the following instructions
to
install.
Align mounting hole in bottom oven trim to holes in the
oven frame.
With one #8-18 x 3/8"screw for each side of the trim,
fasten trim securely to the oven frame.
IMPORTANT: Do not block air intake along bottom of oven.
5. Replace oven racks.
6. Grasp door at each side.
7. Replace oven door by aligning and inserting ends of hinges
into hinge slots in the oven frame.
8. Push hinges in as far as they will go and open the oven door
to the full open position. You should feel the oven door drop
into place.
9. Using a Phillips screwdriver, reinstall the hinge cover plate
with a screw on each side of the oven.
10. Check that door is free to open and close. If it is not, repeat
the removal and installation procedures. See "Prepare Built-In
Oven" section.
11. Repeat for lower oven door.
12. Reconnect power.
13. Display panel will light briefly, and "PF" should appear in the
display.
14. If display panel does not light, please reference the
"Assistance
or Service" section of the Use and Care Guide or
contact the dealer from whom you purchased your oven.
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For oven use and cleaning, read the Use and Care Guide.
Check Operation
of Oven(s)
1. Turn power on. The time should flash in the display.
2. Check that the oven door(s) is closed
3. Turn on the oven(s) Broil function. See the Use and Care guide
for instructions.
If oven(s) does not operate, check the following:
Household fuse is intact and tight; or circuit breaker has
not tripped.
Electrical supply is connected.
See "Troubleshooting"
section in the Use and Care Guide.
4. When oven has been on for 5 minutes, feel for heat.
If you do not feel heat or if an "F" followed by a number
appears in the display, turn off the oven and contact a
qualified technician.
5. Press CANCEL.
If you need Assistance
or Service:
Please reference the "Assistance or Service" section of the Use
and Care Guide or contact the dealer from whom you purchased
your built-in oven.
8

Advertisement

loading