Related Manuals for Water Factory Systems CoolerMATE
Summary of Contents for Water Factory Systems CoolerMATE
- Page 1 Owner's Manual This Manual is for the Installation, Operation, and Maintenance of the WATER FACTORY SYSTEMS CoolerMATE Drinking Water Appliances © 2001 CUNO Incorporated 98-9100 1101...
-
Page 2: Table Of Contents
Table of Contents I. Installation Requirements ..................3 II. Water Supply Requirements ..................3 III. Installation Procedure ..................3 A. Water Supply Connection ..................3 B. Mounting the System ..................3 C. Tubing Connections ....................4 D. System Startup ....................4 IV. System Maintenance ....................4 A. Replacing Filter Cartridges ................4 Installation Diagram ....................5 CM-1 CTO/CM-2 CTO/CM-2 Lead Plus..............5 CMF-350 DWS ......................6... -
Page 3: Installation Requirements
2) Cut the special double-sided adhesive tape to fit the back of the mounting bracket. 3) Remove the backing from one side of the tape and apply it firmly to the back of the CoolerMate bracket. Bracket must be clean of oil and fingerprints and perfectly dry. If necessary wipe clean with window cleaner, alcohol or suitable residue-free cleaner. -
Page 4: Tubing Connections
In some cases it may not be possible or desirable to use the tape mounting method. There are two mounting holes in the system bracket that provides a variety of options for bolting or hanging the CoolerMate on the cooler. In some cases, existing screws can be used. -
Page 5: Installation Diagram
® CoolerMATE Installation Diagram Models CM-1 CTO, CM-2 CTO, CM-2 Lead Plus To Cooler Outlet Fitting with Flow Control Feedwater Inlet Ball Valve To Cooler From Feedwater Source Outlet Fitting with Flow Control Model Feedwater Inlet CM-1 CTO Ball Valve... -
Page 6: Cmf-350 Dws
CoolerMATE ® Installation Diagram Models CMF-350 DWS, CMR-350 DWS To Cooler Outlet Fitting with Flow Control Feedwater Inlet From Feedwater Source Ball Valve Ball Valve From Feedwater Source Feedwater Inlet Model CMF-350 DWS Outlet Fitting with Flow Control To Cooler... -
Page 7: Push-In" Connectors
‘Push-In’ Tubing Connector This product is outfitted with user friendly ‘Push In’ connectors. Proper use of the connectors is shown in the diagrams. It is most important that the tubing selected for use with these connectors be of high quality, exact size and roundness, and with no surface nicks or scratches. - Page 8 CUNO Incorporated 400 Research Parkway Meriden, CT 06450 USA Toll Free 1-800-733-1199 Worldwide 1-203-237-5541 Fax 1-203-238-8701 www.waterfactorysystems.com • www.cuno.com...