Related Manuals for Water Factory Systems FaucetMATE
Summary of Contents for Water Factory Systems FaucetMATE
- Page 1 ® Owner's Manual This Manual is for the Installation, Operation, and Maintenance of the WATER FACTORY SYSTEMS ® FaucetMATE Drinking Water Appliance © 2002 CUNO Incorporated 98-91121 0902...
- Page 2 Check the Performance Data Sheet for the performance characteristics and the conditions of use. The Water Factory Systems’ drinking water appliances are designed to connect per- manently to a home plumbing system. To ensure that the installation conforms to your...
- Page 3 The FaucetMATE line consists of the FM-2 CTO for reduction of chlorine, taste and odors, the FM-2 Lead for the reduction of lead, chlorine, taste and odors, and the FM350-DWS for the reduction of volatile organic chemicals (VOCs), MTBE, lead, chlorine, taste and odors, sediment and mirco organisms such as cysts.
- Page 4 F. Make the faucet mounting hole Procedure: 1) Mark the center for the 9/16" hole. IMPORTANT: It is mandatory that safety glasses by worn during 2) Form a shallow putty dam around the hole area and fill it the sink hole drilling operations in order to prevent eye injury. with enough water to lubricate the carbide drill bit.
- Page 5 I. Installing the feed water valve J. Make tubing connections The saddle tapping valve which is supplied is designed to be NOTE: With all of the components in place, the tubing connections used on 3/8” - 1/2” OD soft copper tubing (plain or chromed) can be made.
- Page 6 Figure 1 Faucet Feedwater Valve FM-2 & FM-2 Lead Plus Figure 2 Rubber Washer Chrome Base Plate Rubber Washer Plastic Bottom Washer Star Washer Hex Nut...
- Page 7 Figure 3 Valve Handle Stem Nut/Seal Piercing Lance Insert Plastic Sleeve Compression Nut 1/4" Orange Feedwater Tubing For 3/8" OD tubing, use the side of For 7/16" to 1/2" OD tubing or rigid pipe, the bracket with the projections. use the "V" side of the bracket. Figure 4 ‘Push-In’...
- Page 8 Figure 5 To Faucet Outlet Fitting with Flow Control Feedwater Inlet From Feedwater Source FM-350 DWS NOTE: Some state and local plumbing codes may prohibit the use of saddle-type valves and/or drain connections. The use of saddle-type valves are prohibited in: Alaska, Delaware, Idaho, Kentucky, Massachusetts, Michigan, Minnesota, New Hampshire, North Dakota, Ohio, Oregon, and South Dakota.
- Page 9 CUNO Incorporated 400 Research Parkway Meriden, CT 06450, U.S.A. Toll Free: 1-800-733-1199 Worldwide: 203-237-5541 Fax: 203-238-8701 www.waterfactorysystems.com • www.cuno.com...