Table of Contents
Advertisement
Monitoring the Input/Output Signal
2.8
Monitoring the Input/Output Signal
On the front panel of the 7226HT transmitter and the 7226HR
Receiver is a F-Connector. This connector, which is labeled RF Test,
is used to monitor the Input RF signal transmitted to the
Transmitter and the RF output signal transmitted from the Receiver.
To Monitor the Signal
1. Using a coax cable, connect the RF Test Port to the test
equipment.
2. The Test Port Coupling is 20 dBc.
page 16
Document no. 93-005-50-A
Advertisement
Table of Contents
