Electromagnetic Compatibility; Table 1. Electromagnetic Emission - Embla Sandman User Manual

SD32+
System

1.5. electromagnetic compatibility

This device is designed for use in environments that comply with IEC 60601-1-2:2001 as indicated
in the tables shown. You must ensure that the device is used in compliance with the IEC
standards.
Emission Test
Radiated and Conducted RF
emission
CISPR 11
Harmonic emission
IEC 61000-3-2
Voltage fluctuations/flicker
emissions
IEC 61000-3-3

Table 1. electromagnetic emission

Immunity Test IEC 60601-1-2 Test Level
Electrostatic 6 kV direct contact
Discharge
8 kV through air
(ESD)
IEC 61000-4-2
Electrical fast 2 kV for power supply line
transient/burst
1 kV for input/output line
IEC 61000-4-4 >3m
Surge 1 kV differential mode
IEC 61000-4-5 2 kV common mode
Voltage dips, 0% of rated voltage (voltage
short dip 100%) for 0.5 cycles
interruptions
40% of rated voltage
and voltage
(voltage dip 60%) for 5
variation on
cycles
power supply
70% of rated voltage
input lines
(voltage dip 30%) for 25
cycles
IEC 61000-4-11
0% of rated voltage (voltage
dip 100%) for 5 cycles
Compliance Electromagnetic Environment
Class B The device is suitable for use in domestic and
other environments that are connected to a low
voltage power supply.
Group 1 The internal operation uses a low RF. The
emission is not likely to cause interference with
nearby electronic equipment.
Complies The device may be connected directly to a low
voltage supply using an electrical ground.
Complies The device may be connected directly to a low
voltage supply using an electrical ground.
Compliance
IEC 60601-1-2 Test
Levels
IEC 60601-1-2 Test
Levels
IEC 60601-1-2 Test
Levels
General Warnings and Cautions
Electromagnetic
environment
Residential
(Note 1)
Residential
(Note 2)
(Note 3)
Residential
(Note 2)
(Note 3)
Residential
(Note 2)
(Note 3)
3