Yamaha WOLVERINE YFM45FXX Owner's Manual page 23

EBU18100
Start switch " "
Push this switch to crank the engine with the start-
er.
ECB00050
CAUTION:
See the starting instructions on page 6-1 prior
to starting the engine.
EBU18151
Light switch " /
Set this switch to "
and the taillight. Set the switch to "
the high beams and the taillight. Set the switch to
"OFF" to turn off all the lights.
ECB00040
CAUTION:
Do not use the headlights with the engine
turned off for an extended period of time, oth-
erwise the battery may discharge to the point
that the starter motor will not operate properly.
If this should happen, remove the battery and
recharge it.
/OFF"
" to turn on the low beams
" to turn on
EBU28210
On-Command four-wheel-drive switch
"2WD"/"4WD"
This ATV is equipped with a switch to change from
two-wheel drive to four-wheel drive and vice-versa.
Select the appropriate drive according to the ter-
rain and the conditions.
G
"2WD" (two-wheel drive): Power is supplied to
the rear wheels.
G
"4WD" (four-wheel drive): Power is supplied to
the rear and front wheels.
To change from two-wheel drive to four-wheel
drive, stop the ATV and push the switch in to the
"4WD" position.
indicator " " comes on in the speedometer unit
display.
To change from four-wheel drive to two-wheel
drive, stop the ATV and push the switch in to the
"2WD" position.
4-5
Then, the four-wheel-drive
4