Section 12-Seat; Removing/Installing Seat Pan; Flush Mount - Invacare Solara Service Manual

Hide thumbs Also See for Solara:

Table of Contents

SECTION 5—SEAT

After any adjustments, repair or service and BEFORE use, make sure all attaching

hardware is tightened securely - otherwise injury or damage may occur.

NOTE: Refer to FIGURE 5.1 for this procedure.

REMOVING

1. Remove the seat cushion from the seat pan.

2. Do one (1) of the following:

A. Short Frame - Remove the four (4) mounting screws and locknuts that secure

existing seat pan and seat pan supports to wheelchair frame.

B. Medium or Long Frame - Remove the six (6) mounting screws, locknuts and two

(2) coved spacers that secure the existing seat pan and seat pan supports to the

wheelchair frame.

INSTALLING

1. Install new seat pan and existing seat pan supports onto the wheelchair frame as

shown in FIGURE 5.1.

2. Do one (1) of the following:

A. Short Frame - Secure the seat pan and seat pan supports to the wheelchair frame

with the four (4) mounting screws and locknuts.

B. Medium or Long Frame - Secure the seat pan and seat pan supports to the

wheelchair frame with the six (6) mounting screws, locknuts and two (2) coved

spacers. Refer to FIGURE 5.1 for proper hardware orientation.

3. Reinstall seat cushion onto seat pan.

™

Solara

and Solara

Limited

WARNING

Part No 1085787

Table of Contents

Solara limited