Related Manuals for Draper PP12
Summary of Contents for Draper PP12
- Page 1 12V POWER PACK WITH 230V/A.C. OUTPUT INVERTER STOCK No.56364. PART No.PP12/230V. • INSTRUCTIONS • IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY TO ENSURE THE SAFE AND EFFECTIVE USE OF THIS POWER PACK. 01/99...
-
Page 2: Table Of Contents
PART No.PP12/230V. Whilst every effort has been made to ensure accuracy of information given in this manual is correct at the time of going to print, the Draper Tools policy of continuous improvement determines the right to change specification without notice. -
Page 3: Features
FEATURES IMPORTANT: Read and understand these instructions before using the power pack. Correct use and storage will keep it in good condition and ensure trouble free operation. Power pack must be charged before initial use. The unit is powered by an internal, rechargeable battery which produces 12V of direct current (D.C.). It also features an internal power inverter which converts 12V direct current (D.C.) to household current (230V/A.C.). -
Page 4: Charging
Disconnect the negative (-) power cable from the vehicle earth point. Disconnect the positive (+) power cable from the vehicle battery terminal. NOTE:- We would advise the use of the Draper voltage surge protector Stock No.39107 when using this power pack for jump starting. - 3 -... -
Page 5: Jump Starting
JUMP STARTING - continued NOTE:- If possible, the vehicle should be started by a second person as soon as the negative (-) connection is made to the vehicle earth in order to maximize the power boost to the battery. If the vehicle does not start within 10 seconds, turn the ignition off and allow the internal battery to cool for approximately three minutes before attempting to start the vehicle again. -
Page 6: Inverter Safety Features
INVERTER SAFETY FEATURES Overload protection The internal inverter is designed to operate appliances and equipment which draw no more than 230W of continuous power. Operating appliances or equipment with higher continuous power requirements will overload the inverter. In the event of an overload, the internal circuit breaker will interrupt the power to the A.C. outlet and the A.C. power indicator will flash. -
Page 7: Safety Precautions
This guarantee applies in lieu of any other guarantee expressed or implied and variations of its terms are not authorised. Your Draper guarantee is not effective unless you can produce upon request a dated receipt or invoice to verify your proof of purchase within the 12 month period. - Page 8 ©Published by Draper Tools Ltd. No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, mechanical photocopying, recording or otherwise without prior permission in writing from Draper Tools Ltd.
Need help?
Do you have a question about the PP12 and is the answer not in the manual?
Questions and answers