FlyTech Dragonfly User Manual page 6

To operate the FlyTech Dragonfly:
1. Turn the controller on by pressing the power switch. The LED indicator will blink.
2. Extend the antenna on the controller.
3. Turn the FlyTech Dragonfly on by setting the switch on the dragonfly to ON.
NOTE: If the controller is off when you turn on the dragonfly, the dragonfly's eyes
will blink.
4. On the controller, push the left stick upwards
to increase speed of the wing-flapping. The
left stick (throttle) controls how high and fast
your FlyTech Dragonfly will fly.
NOTE: Push the left stick once first to arm the
dragonfly and again to start the wings flapping.
5. Launch FlyTech Dragonfly
from your hand with a
gentle horizontal motion.
The dragonfly will flutter
away from you.
NOTE: Do not throw the
dragonfly when launching.
6. On the controller, push the right stick (directional) to the left to turn left, or push
the stick to the right to turn right.
Use smaller movements on
the controller to make the
dragonfly turn more gradually.
To make the dragonfly turn
more quickly, push the stick
further in the desired direction.
Trimming
Use the trim dial to adjust the straight line flight of the dragonfly. If the dragonfly
naturally steers to the right, slowly turn the trim dial in a clockwise direction to
adjust the steer.
Hold parallel to the Do not tilt up
ground to launch
Do not tilt down