FlyTech Dragonfly User Manual page 4

To charge the dragonfly:
1. On the controller, push down on the magnetic perch. The cord compartment
door will open.
2. Pull the end of the cord from the compartment as shown.
3. Hold the dragonfly firmly by its body, and then insert the cord into the socket as
shown. Pay close attention to the orientation of the socket and the connector on
the cord.
NOTE: Make sure that the dragonfly is turned off before you recharge it.
IMPORTANT: Do not force the cord into the
socket – this can damage the socket. The
exposed silver contact points on the side of
the controller plug should line up with the
cut-away side of the socket.
NOTE: The controller is equipped with a sleep feature. The LED indicator will
turn off if the controller is idle for more than 1 minute. Therefore, when charging
FlyTech Dragonfly, the LED indicator light might turn off, however, the controller
will continue to charge the dragonfly. To turn the LED indicator light back on,
press the power button on the controller until the LED indicator lights up again.
4. Press the power button on the controller to turn it on.
If the connector on the cord is properly connected to the socket, the eyes on the
dragonfly will pulse slowly to indicate that it is charging.
Note that the eyes will blink rapidly if there is no signal from the controller.
When charging the dragonfly, make sure the cord from the controller is properly
connected to the socket on the dragonfly.
NOTE: You can rest the
dragonfly on the controller
while it is charging by placing
the metal perch point (on the
dragonfly) on the magnetic
perch (on the controller).