Foxconn G31S Series User's Manual & Installation And Servicing Instructions page 43

USb Devices Setting
USB 1.1 Controller
USB 2.0 Controller
USB Operation Mode
USB Keyboard Function
USB Mouse Function
*** USB Mass Storage Device Boot Setting ***
↑↓→←:Move Enter:Select
► USB 1.1 Controller
This item is used to enable or disable the Universal Host Controller Interface for USB.
► USB 2.0 Controller
This item is used to enable or disable the Enhanced Host Controller Interface for USB.
► USB Operation Mode
This item is used to set the USB operation mode. If you select the [High Speed], then the USB
operation mode is determined by the USB device; select [Full/Low Speed], the USB device
operates on full/low speed.
► USB Keyboard Function
This item is used to enable the support for USB keyboard on legacy OS. If you have a USB
keyboard, set to auto or enabled.
► USB Mouse Function
This item is used to enable the support for USB mouse on legacy OS. If you have a USB
mouse, set to auto or enabled.
► ***USB Mass Storage Device Boot Setting***
BIOS auto detects the presence of USB Mass Storage Devices, you can configure the Boot
setting mode for the detected USB MSD. Setting Options: [Auto]; [FDD Mode]; [HDD Mode]
Phoenix - AwardBIOS CMOS Setup Utility
USB Devices Setting
[Enabled]
Enabled
[Enabled]
[High Speed]
[Enabled]
[Enabled]
+/-/PU/PD:Value F10:Save
F5: Previous Values F7: Optimized Defaults
36
Item Help
Menu Level ►
[Enabled] / [Disabled]
Universal Host
Controller Interface
for Universal Serial
Bus .
ESC:Exit F1:General Help