Appendix 2. -The Arp Function - Sony IMX035 Installation & Operation Manual

APPENDIX 2. –The ARP function
Setting the IP Address
The Ethernet interface on the IP camera has a default IP address (192.168.1.168) that most likely
needs to be changed to make it work on your local network. You need to acquire a unique IP
address (ask your network administrator). For the initial setting of the IP address, the IP camera
needs to be connected to the same network segment as your client, and the IP address can then be
configured by using a combination of ARP and ping command.
Use any of the following ways to set the IP address within thirty seconds after booting the IP camera
(re-cycle the power). Setting IP using the method below can only be done on the Ethernet interface.
ARP and ping from Windows or MS-DOS:
You can open the PC's MS-DOS windows from the WINDOWS 98 operation system, or open the
PC's Command Prompt windows from either the WINDOWS 2000 or the WINDOWS XP operation
system.
1.
Start a DOS prompt window.
2.
Type in the following 30 seconds after the booting:
arp -s <IP address> <Ethernet address>
[or arp -s <IP address> < MAC address>]
ping <IP address>
Example:
arp -s 192.168.1.100 00-0C-0C-00-00-01
ping 192.168.1.100
The IP address now is: 192.168.1.100.
94