Advertisement
Quick Links
Advertisement
Related Manuals for Vectra Fitness VX-FT
Summary of Contents for Vectra Fitness VX-FT
- Page 1 VX-FT Owner’s Manual...
-
Page 2: Routine Inspection & Maintenance
Vectra Fitness appreciate your selection of our product for your fitness program, and are struck by falling weights or invite your questions and comments. We're sure that you’ll be pleased with your new Vectra Fitness moving parts. The risk that you assume by using this type of equipment gym. - Page 3 Vectra VX-FT Cable Diagrams ® Note: Keep the Cable Routing Tubes for use when the cable needs replacing. CABLE REPLACEMENT PROCEDURE: The cable has a large fitting on each end that will not fit around the 1L, 1R or central pulleys. To replace the cable, first attach a cable routing tube to each cable end. Secure it with tape (see the cable installation procedure on the other side).
- Page 4 Conditions and Exceptions: Failures due to misuse, abuse, neglect, alteration, improper assembly, repairs other than by an authorized Vectra Service Center, normal wear, damage or lack of maintenance are not covered. Use of a weight stack that is heavier than the heaviest stack that Vectra Fitness sells for use on the machine voids this Limited Warranty.
-
Page 5: Tools Required
Remove the two Lower Pivot Covers (C) using a screwdriver and set aside. FIG. 1 Authorized Frame Configurations: The VX-FT is part of the modular Series VX. Please select the configuration you are assembling from the list below and follow the associated instructions. FREESTANDING: For a Freestanding VX-FT a Freestanding Frame (D) is required, Fig. - Page 6 Now install the weight stack inside the Column Assembly (B) from the top. Ensure that the guide rods are in place as mentioned in step 3 above. Lift the guide rods up one at a time and position the rubber stack bumper on its bottom. Do this by reaching in the slot on the front of the column. Replace the guide rods through holes in the base of the column.
- Page 7 After all plates are in the column, assemble the top plate and the selector shaft to the Top Plate Pulley (K), securing with 3/8-16 X 3 hex bolt. The Top Plate Pulley includes one, two or three pulleys for the 2:1, 4:1 and 6:1 cable systems respectively. Ensure that the Top Plate is rotated such that its curved front is aligned with the cable coming from the side of the Upper Pulley Assembly (L) with the toothed adjustable pulley, see FIG.3.
- Page 8 Now test the adjustability of each arm. Operating the release lever will simultaneously pull a pin in both the upper and lower pivot areas. Check that each arm is free to move both horizontally and vertically. Letting go of the lever should allow both pins to latch once the arms rotate far enough for the pin to align with a slot.