F O R
You have purchased an amplifier that leads the way with sound quality, reliability,
and features. These high performance amplifiers deliver what you ask for:
smooth, effortless listening, or hard driving power to get you down the road.
LINEAR POWER™ has been a name recognized since 1975 as a product
delivering high quality and audio excellence. Now, you have the results of that
experience.
The Series 218
DPS500
©
pass, low-pass, or bypass cross-over filter; high current, gold plated power
connector; gold plated 5-way binding post speaker connections; our DPS
(dynamic power supply) system; our innovative configurable PMT
management technology) circuitry for maximum power into 2-ohm AND 4-ohm
speaker loads; panel mount fuse; large package TO 218 output transistors;
mega-mass, high contour heat sink; reversible nameplate; and LINEAR
POWER™ reliability and commitment to excellence. Enjoy the Music!!
The DPS500
is NOT 2-ohm mono stable. While it may be used in 2-ohm
©
stereo, if you hook-up this amplifier in 2-ohm mono it will DAMAGE the unit and
VOID your warranty. Be sure the PMT
configuration. For further information on this, or assistance to calculate your total
speaker load impedance, please call T.I.P.S. Inc. (see info under Service or
Repair heading)
Please read through this entire section before installing your amplifier in the
vehicle. Disconnect the negative (-) battery terminal in your vehicle and remove
the fuse from the amplifier before making or breaking any connections. Do not
install power line fuse at battery or amp until the installation of your amplifier is
complete.
T H E
L
O
V
SERIES 218
DPS500
OWNER'S MANUAL AND
INSTALLATION GUIDE
INTRODUCTION
features include: frequency programmable high-
©
IMPORTANT NOTICE
circuitry is set to the correct
©
CONTROLS and CONNECTIONS
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED
LINEAR POWER™ is a trademark of Linear Power, Inc.
E
O
F
M
U
S
©
©
™
I
C
©
(power
©
1