Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Moduline systems A
Summary of Contents for Moduline systems A
- Page 1 Reliable liquid dispensing at an affordable price Model A Dispenser Operation Manual 12513 Loma Rica Dr., Grass Valley, CA 95945 Phone: (530) 272-8786 / Fax: (530) 272-1638 Email: info@modulinesystems.com Web: www.modulinesystems.com Moduline Systems\Manuals\Model A Ver 2/20/13...
-
Page 2: Table Of Contents
Final Setup for Use as an Automated Dispenser Using the System Clean Up Figures (1) Model A Dispenser – Front View with Syringe Installed a. Detail of Syringe Adjustment Mechanism & Placement of Actuator Fork b. Detail View of 2 mL Syringe c. -
Page 3: Introduction
2. Determine the required syringe volume setting. For single needle dispensing the volume setting is simply the desired volume. When a manifold is to be used the volume setting is the total of all of the well volumes being filled. Example: Desired 100 µL per well... -
Page 4: Final Setup For Use As An Automated Dispenser
INSTALLING OR REMOVING THE COMMUNICATION CABLE. FAILURE TO DO SO MAY DAMAGE ELECTRONIC COMPONENTS. 1. Connect one end of the communication cable to the rear of the Model A and the other to the rear of the conveyor. 2. Connect the inlet fluid line to the syringe’s inlet (bottom) port. - Page 5 Reliable liquid dispensing at an affordable price 3. Hold down the hand control dispense button or initiate a prime cycle by moving the prime switch to the down position until all reagent has been removed from the system. 4. After the system is empty, it should be flushed with an appropriate cleaning solution, if desired, and finally with distilled water.
-
Page 6: Model A Dispenser - Front View With Syringe Installed
Reliable liquid dispensing at an affordable price... -
Page 7: Model A Dispenser - Back Panel
Reliable liquid dispensing at an affordable price... -
Page 8: Model A Hand Control With Dispense Manifold & Needle
Reliable liquid dispensing at an affordable price... -
Page 9: Specifications
2 Model A dispensers with 8 port manifolds 2 Model A dispensers with 16 port manifolds Regulatory Compliance The Model A is a general laboratory device not subject to FDA regulatory approval. UL / CE approved components are used wherever possible.
Need help?
Do you have a question about the A and is the answer not in the manual?
Questions and answers