Sony NEX-5T User Manual page 241

The setting is reset without the resetting operation.
• The battery pack was removed when the power switch was set to ON. When removing the battery
pack, make sure the camera is turned off and the access lamp is not lit.
The camera does not work properly.
• Turn off the camera. Remove the battery pack and insert it again. If the camera is hot, remove the
battery pack, and allow it to cool down before trying this corrective procedure.
• If an AC-PW20 AC Adaptor (sold separately) is used, disconnect the power cord. Connect the power
cord and turn on the camera again. If the camera does not work after trying these solutions, consult
your Sony dealer or local authorized Sony service facility.
"--E-" appears on the screen.
• Remove the memory card, and insert it again. If the problem persists even after performing this
procedure, format the memory card (page 187).
The buttons on the touch panel do not work correctly or do not work at all (NEX-
5R only).
• If you cover the panel with a commercially available protective film, the panel may not operate.
• If you are touching somewhere other than the point you should touch, the panel may not operate
properly.
• Some operations cannot be done on the touch panel. In this case, use the control wheel and buttons.
• Perform [Calibration] (page 183).
GB
228