Advertisement
S
ETTING THE TEMPERATURE
AND THE STEAM LEVEL
1. Place the thermostat control
(
) to match the type of fabric
H
to be ironed.
The light comes on (
the light to go off and come on
again before you start ironing
Our advice
Start with the fabrics to be ironed on a low temperature (•) and finish with those
which respond best to higher temperatures (••• or MAX)
If you iron a fabric made of a blend of fibres: set the temperature for the most
delicate fibre.
To improve ironing efficiency, this iron produces steam on the "synthetics" position,
thanks to a new sole plate design which allows you to iron delicate fabrics with
steam on a low setting.
2. Place the Steam Control (
The production of steam automatically adjusts
to the temperature selected.
!
Important
• Your iron will only produce steam when the thermostat
control is in the steam zone. When first switching on
the iron wait for 5 minutes after the iron is switched on for
steam to be produced.
• If you lower the thermostat, wait until the light goes out and comes on again before
ironing.
A
-
UTO
STOP SAFETY FEATURE
(depending on the model)
The electronic system cuts the power off and the auto-stop warning light
(
) flashes if the iron is left vertically on its heel for more than 8 minutes
L
or for more than 30 seconds if left horizontal.
To restart the iron, shake it gently until the warning light stops flashing.
NB. When the auto-stop safety switch operates, the thermostat light will
remain off.
A
-
NTI
DRIP FUNCTION
Prevents drips whilst ironing.
V
ERTICAL STEAM
1. Hang the garment up and hold the fabric taut
2. Place the thermostat control (
press repeatedly on the Burst of Steam
button
and move the iron from top to
bottom.
!
Important
Hold the iron a few centimetres from the garment to
avoid burning delicate fabrics.
R
EMOVING THE STUBBORN CREASES
Press repeatedly on the Spray button
dampen the fabric.
or
Use the Burst of Steam button
or three times in quick succession to obtain a
more powerful burst of steam.
!
Important
Never use the Burst of Steam button
synthetics.
T
O IRON LINEN OR COTTON
WITH A HIGH FLOW OF STEAM
1. Set the thermostat control to Linen or Cotton.
2. Press the "Jeans" (
model) trigger while ironing. This increases the
flow of steam.
3. Do not press the trigger (depending on the
model) for more than 30 seconds. Wait a
minute before using it again.
I
RONING WITHOUT STEAM
Place the Steam control (
indicator light (
). Wait for
I
) on .
G
H
) (depending on the
K
) on DRY
G
) comes on for the second time.
I
Linen
Cotton
Wool
(
Silk
Viscose)
Synthetics
(Acetate, Acrylic,
Polyamide,
Polyester)
) on MAX,
to
pressing two
on silk and
. You can start ironing when the
2
3
4
5
6
7
8
Advertisement
