Overview; Installation; Is4 Required Mounting Space - Pentair iS4 Installation And User Manual

1

OVERVIEW

iS4 Spa-Side Remote Control
The iS4 Spa-Side Control can be used with the Pentair
EasyTouch Control Systems and the Compool
®
to provide remote switching of four control circuits from the spa location. It
is typically used for activating spa circulation and three auxiliary pieces of
equipment (such as lights, jet pump, air blower, etc.). One iS4 spa-side control
can be installed per control system. It is possible to install two iS4 remotes on
a single control system, however, the two iS4 remotes will mirror each other
in functionality. The iS4 spa-side remote is a double-insulated device UL and
ETL listed to UL 1563. It is splash-proof and weatherproof but should not be
permanently submerged below the spa water level. The iS4 remote must be
installed above the highest sustained water level.
The iS4 Spa-Side Remote red LED status light functions are as follows:
Spa Mode
Heating
When used with any Pentair Control System:
Voltage:
Current:
iS4 Kit Contents
· Spa-side remote (with cable attached)
· iS4 Mounting Adapter (for acrylic spa and upgrade from SS4)
· Label Set

INSTALLATION

The iS4 spa-side remote is a double-insulated, waterproof device for installation at the
water's edge. It is typically installed at the tile-line of the spa wall, or in the deck within
arm's reach of a spa occupant. It can be used with a gunite spa, acrylic spa, or hot-tub.
However, in order to install the spa-side remote into the wall of a gunite spa, provision
must be made while the spa is being plumbed.

iS4 Required Mounting Space

To install the iS4 Spa-Side Remote into the wall of a gunite spa, provision must
be made while the spa is being plumbed. For surface mounting (protruding
from deck, tile or uneven surface), When installed, the iS4 remote requires the
following space:
Flat Faceplate:
Skirted Faceplate:
Material:
iS4 Spa Side Remote Installation and User's Guide
N/A
N/A
5 VDC
2 mA maximum
®
Steady Steady Steady
N/A Flashing Flashing
6-1/2" x 3-1/2"
6" x 2-5/8" x 1-1/4" high
ABS plastic
IntelliTouch
®
CP series Control Systems
,
®