Archos 9 pctablet User Manual page 15

United States FCC Compliance Statement
This equipment has been tested and found to comply with limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with instructions, may cause harmful interference to radio communications. However, there is no guar-
antee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's author-
ity to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices).
USA: - This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement: This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This trans-
mitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Canada: - Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
CE Mark
This device conforms to the directives, norms, and amendments for products commercialized in the European Union and thus carries the CE marking.
Declaration of Conformity for the European Union
Your exposure to radio frequency energy is well below the limits set forth by the European commission for the R&TTE norms. This product respects the following norms:
-
R&TTE directive 1999/5/EC : EN 300 328, EN 301 489-1, EN 301 489-17, EN 301 893
-
EMC 89/336/EEC with modifications 92/31/EEC and 93/68/EEC: EN 55022 Class B, EN 61000-3-2, EN 61000-3-3, EN 55024
-
Low voltage electrical norm 73/23/EEC: EN 60950 (A1/A2/A3/A4/A11)
WIFI Transmitter & Receiver
This device is equipped with Wifi capabilities and thus is able to receive and transmit in the radio frequency band of 2.4GHz. It is considered a low power
transmitter and thus has special restrictions.