Aligning Fence; Miter Gauge - Grizzly EXTREME G0513X2 Owner's Manual

Aligning Fence

To ensure cutting accuracy when the fence is first
installed, the fence should be aligned with the
miter slot.
To align the fence parallel with the miter slot:
1. If the fence is mounted on the left-hand side
of the blade, remove it and remount it next to
the miter slot.
2.
Loosen the four cap screws located on the
top face of the fence (Figure 35).
Figure 35. Four fence cap screws.
3. Adjust the fence face parallel with the edge of
the miter slot.
4.
Tighten the four cap screws, being careful not
to move the fence.
NOTICE
Adjusting the fence parallel to the miter slot
does not guarantee straight cuts. The miter
slot may need to be adjusted parallel to
the side of the blade. Refer to the "Aligning
Table" instructions.
G0513X/G0514X/G0514X3 Extreme Series Bandsaw

Miter Gauge

The miter gauge needs to be calibrated to the
blade when it is first mounted in the miter slot.
To calibrate the miter gauge:
1. Use a machinist's square with one edge
against the face of the miter gauge and the
other against the blade face as shown in
Figure 36.
Figure 36. Squaring miter gauge to blade.
2.
Loosen the lock knob on the miter gauge and
adjust it flush with the edge of the square.
3. Tighten the lock knob, and verify the setting.
Note: Sometimes the tightening procedure
can affect the adjustment.
4. Loosen the screw that secures the angle
pointer and adjust the pointer to the 0˚ mark
on the scale.
5.
Retighten the screw that secures the angle
pointer.
-31-